I'm replacing both front CV axles and intermediate shaft. The axles I'm getting reman'd from Napa.
The intermediate shaft is available from Crown for $80 or Omix-ADA for $125ish.
All bushings (except for steering rack), ball joints, wheel hubs have been replaced in last 4 months.
The intermediate shaft is available from Crown for $80 or Omix-ADA for $125ish.
- Is Crown fine or should I spend the extra for an Omix-ADA?
- Should I pick up seals and bearings?
- How difficult are the seals/bearings to remove/install?
- Will the rent-able tools from Autozone/AdvanceAuto do the job or do I need the specific tools listed in the service manual from the dealer?
- Anything else I should replace while it's apart?
- If I open up my UCA pockets to allow more drop should I run limiting straps?
All bushings (except for steering rack), ball joints, wheel hubs have been replaced in last 4 months.