C
CheddarGau
Full Access Member 39 From Lower Mainland BC
- Joined
- Last seen
- Viewing thread What did you do to your jeep today?
Latest activity Postings About
-
-
CCheddarGau replied to the thread What did you do to your jeep today?.Harmonic balancer is common on those 4.0L engines. See if it's separated.
-
CCheddarGau replied to the thread What did you do to your jeep today?.Ok I looked up the bushings and there are 3 part numbers available. 52125391AC is the updated part number to the one that is in your...
-
CCheddarGau replied to the thread What did you do to your jeep today?.Factory ones were made by Dana and went in a lot of vehicles. Clutches are a wearable component, and are definitely a rebuildable...
-
CCheddarGau replied to the thread What did you do to your jeep today?.I'll have a look at part numbers later on.
-
CCheddarGau reacted to CherokeeLiberty's post in the thread What did you do to your jeep today? with
Like.
I pulled a partially uprooted stump out with it today. 4Low is a wonderful thing. -
CGave my ac a squirt of gas, stopped it short cycling. Back to lovely cool air.
-
CCheddarGau replied to the thread What did you do to your jeep today?.First real opportunity to test out the clutch LSD in the rear and the truetrac torsen LSD in the front. The rear performed amazingly...
-
CCheddarGau replied to the thread What did you do to your jeep today?.Went down Chehalis FSR with thr boys
-
-
CCheddarGau replied to the thread What did you do to your jeep today?.Rebuild the lsd with new clutches before you put it in.
-
CCheddarGau replied to the thread What did you do to your jeep today?.Just remember timing chains are most likely to jump sprockets on deceleration. Just don't do any big engine braking and it's less likely...
-
CMy preferred solution is the Air Lift rear coil helpers. They work exceptionally well, and make the rear end a progressive rate spring.
-
CCheddarGau replied to the thread What did you do to your jeep today?.Thats before and after the load leveling shocks. HD front and rear springs are always in and the rear sat lower than the fronts. When...
-
-
CCheddarGau reacted to allengerdes's post in the thread What did you do to your jeep today? with Like.
These are my OME springs with Belstein shocks/struts.
-
CCheddarGau replied to the thread What did you do to your jeep today?.Get some Monroe load adjust rear shocks (for dodge dakota) if you find your front end is too high. I got the HD front and rear springs...
-
CCheddarGau replied to the thread What did you do to your jeep today?.I did a few months back, I think another person did one since that time. The hardest part is finding the front ring and pinion set. Part...
-
-
Loading…
-
Loading…
