duderz7
Latest activity Postings About
-
-
I installed an Iron Rock and forgot about it. -
duderz7 replied to the thread Someone please help me.I agree with the above. If the cap isn't holding pressure coolant will boil at or below operating temp. Water under pressure has a...
-
Faulty radiator cap can cause this too. Replace the cap if it’s older than 5 yrs old.
-
duderz7 replied to the thread 2006 kj crd rear 8.25 diff c clips.I would suspect they are like the other 8.25's, so yes.
-
duderz7 replied to the thread What did you do to your jeep today?.https://creative-steel.com/shop/jeep/kj-liberty/02-07-jeep-liberty-kj-polyurethane-steering-rack-bushings/ these are the ones you want...
-
duderz7 replied to the thread What did you do to your jeep today?.If your upper control arms were torqued with the suspension drooping it'll cause issues and noises. You could loosen them, bounce the...
-
duderz7 replied to the thread What did you do to your jeep today?.If one motor mount was in need of replacement it's likely the other does as well as the transmission mount.
-
For future reference, you do not necessarily have to buy the more expensive Mopar branded ATF+4 since ANY brand ATF+4 is actually...
-
duderz7 replied to the thread My rear springs on the 2002 kj keep popping off when I'm fully flexed out. I'll post pics below. What can I do to fix this issue . Thanks everyone..You could look into limiting straps at this point, but the proper shock would probably be best. Your current shock may be limiting...
-
You are quite right for normal bushes, unfortunately when they designed the upper arm they put the bushes in the wrong plane for some...
-
duderz7 replied to the thread Rear Upper Control Arm (Boomerang).Didn't stay that way long.:cool:
-
duderz7 replied to the thread Rear Upper Control Arm (Boomerang).is this turning into a show off your IRO?... Or did I totally miss the social que?
-
-
duderz7 reacted to u2slow's post in the thread Rear suspension or axle clunk when getting on or off the gas. with
Like.
Upper arm bushings. They tear. Best viewed when not jacked up. It is very difficult to remove the OEM bushings without stretching the... -
duderz7 replied to the thread Rear suspension or axle clunk when getting on or off the gas..Jack it up by the axle so it's closer to ride height during inspection. The bushings mentioned would be a good place to start, next the...
-
duderz7 replied to the thread Rear upper control arm wont go in all the way.Remove bracket from axle, insert ball joint, reattach bracket to axle.
-
-
Loading…
-
Loading…
