DadOSix
Latest activity Postings Media Albums About
-
-
DadOSix reacted to KJowner's post in the thread 02 Power Steering leak - cannot get it sealed with
Like.
Are they tube nut fittings? If so they might need a backing ring if the inserted pipe is bottoming out before the seal or the nut is... -
DadOSix replied to the thread Exhaust Manifold to Downpipe Gasket? 2005 Liberty Sport 3.7.Not so sure there is one! There is a donut at the inlet of the muffler, but none other that I remember.
-
Our 2006 had this happen in the parking lot of Home Depot! Got the rig home and took the cover off the steering column. Adjacent to the...
-
DadOSix replied to the thread 02 Power Steering leak - cannot get it sealed.Old o-ring or something stuck up in the fitting on the pump? Or a burr on the fitting - inside the pump that cuts the new o-ring when...
-
DadOSix replied to the thread 2008 3.7L Questions Jeep Newbie Daughter's truck down.....!.Depending on where the ‘rattle’ sound is coming from, I am going to suggest, up high? She threw a lash adjuster (known to the rest of...
-
DadOSix replied to the thread Passenger Side (right side) Axle doesn't seem to be in all the way.You may want to compare new and old axles. I * think * this is a function of how long the splines are on the new shaft as compared...
-
DadOSix replied to the thread 2004 Jeep Liberty Rear End Issue.Broken/loose upper control arm ball joint mount. Where the stud for the upper control arm in the rear attaches to the rear...
-
DadOSix replied to the thread Broken sway bar link bolt.Well done! Much more patience that I have these days!
-
Reporting in… I broke it again!!! Here are the two nuts I was using as jam nuts. Well that didn’t work. Well it worked a little. I...
-
DadOSix replied to the thread Camshaft Position Sensor.David - does your scan tool do live data? If so, see if you can find both the cam and crank sensor voltages and signals. Should be 4...
-
DadOSix replied to the thread Broken sway bar link bolt.Perhaps a friend with a portable oxy/acetylene setup could get it hot enough. Dont neglect the old warm bolt melted crayon trick...
-
DadOSix replied to the thread Broken sway bar link bolt.Thanks for that! Didnt realize mapp is no more.
-
DadOSix replied to the thread Bert needs a starter.Follow the video that has you working from below and drop the intermediate shaft from the transfer case to the front punkin. It is a...
-
DadOSix replied to the thread YACNS issue (Yet another crank/no start issue).Fuel pump. Next time it does this, cycle the key on and off a few times before trying to restart. This process will build fuel...
-
Appreciate all the help and guidance of the forum. List is installed. OME all the way around, ARB UCA, Iron Rock UCA/LCA on rear. Double...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
