icarl
Full Access Member
I just replaced mine at over 165000 KMs. But they were shot.With over 100,000.0 miles on the clock, ours still have the Factory installed wheel bearings!
Nothing wrong with them!
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I just replaced mine at over 165000 KMs. But they were shot.With over 100,000.0 miles on the clock, ours still have the Factory installed wheel bearings!
Nothing wrong with them!
O.K. Thanks. The 4.0s I have been around have been both durable & reliable. Just my $.02.
Yes,the KJ,along with 99% of all other new vehicles,use a non-serviceable unit bearing,you must replace the whole unit and no you can not grease them either.if your bearings are shot do you HAVE to buy the whole hub assembly too?
Not seeing the separate bearings for the front,only the unit bearings.The separate bearings listed are listed for the rear axle and stated in the descriptions.damn. then why does rock auto sell just bearings?
http://www.rockauto.com/catalog/raframecatalog.php
not trying to challenge your advice just asking..
Not seeing the separate bearings for the front,only the unit bearings.The separate bearings listed are listed for the rear axle and stated in the descriptions.
Not seeing the separate bearings for the front,only the unit bearings.The separate bearings listed are listed for the rear axle and stated in the descriptions.