duderz7
Full Access Member
"Looks like some mighty fine Mall Crawlin!" Spoken with a southern drawl.
What did you do to your jeep today?
- Thread starter TheQ
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Nah, its what you all call a fairgrounds up north there , no stinkin mud wretchin mall
Im just happier than a pig in slop I got to play around in that white stuff
spoken with a Southern drawl
Im just happier than a pig in slop I got to play around in that white stuff
spoken with a Southern drawl
Tinkrr
Full Access Member
New Front Brake rotors, pads, Calipers, and Brake hoses. 163,000 KM
Second Time, blown brake hose, seized calipers
Second Time, blown brake hose, seized calipers
Not bad , my 04 I swapped out the first set of OE rotors/pads at 102,000 miles and Id say had another 12-15000 on them, but had it tore down, had spare parts so replaced them.
Good job
Never thought of the stone pile
We just got 28 Tri axle dump truck loads of of 57s ( limestone ) in last month ( about 450 ton I think it was )
Had to use the dozer to pile it up , I had the Honda side by side about half way up till I scared the old guy that was with me LOL
Johnny O
Just hangin' out.
I ended up finding an open box Apollo for 100$. Returned the exact same item they nicked me around 200 for. Got it easily installed on the Jeep. Mating it to the snorkel proved a challenge due to 3mm difference in the O.D. of the f.lange... Of course, it is a cast aluminum part and I sold my lathe years ago. Going to have to get creative with the angle grinder and a cordless drill.
CherokeeLiberty
Full Access Member
I did this at school every day in my XJ.
To be honest, this is the first time I have done it since 1980 when I had a 79 F150 step side short bed on 38 inch Gumbo Monster Mudders LOL
and back then that was my daily driver LOL
turblediesel
memberable
Yes, unless the adjustment motors are damaged. My mirror looked like this after a moose kicked it. I thought the jeep was going to the junkyard and I was going to the hospital. Only cost $40.00 for the mirror glass mounted to a backing plate, snapped right in.
Johnny O
Just hangin' out.
I just wanted to bump this part. It had to be done.
Johnny O
Just hangin' out.
Woke up to a very pleasant surprise. My used gas tank armor was delivered from DeadJeep. It is in incredible shape. I was expecting scratches and dings. It was only 129$!
You must be registered for see images attach
You must be registered for see images attach
Looks good! That will make you a little more desert-proof.
Mine isn’t installed yet because I need decent weather to paint it first.
Johnny O
Just hangin' out.
Yeah, was gonna bust that rust, but too chilly and windy today. Supposed to be 15C tomorrow so we’ll see. Got some clean up to do underneath to before mounting. Wish I could find the long plate..
Long plate ???
Oh you mean transmission skid ?
Then you also need transfer case skid
Oh you mean transmission skid ?
Then you also need transfer case skid
Johnny O
Just hangin' out.
Yep. Looking for both.
Edit: to clarify- got the engine plate. The little angle plates are readily available, but that long trans skid has eluded me.
Last edited:
If you ever come across something decent you don't need, drop me a link and I will go buy it.
Johnny O
Just hangin' out.
Been finding lots of NOS transfer skids for 70ish or less. DeadJeep has engine skids for 60. Which ones you after?
Similar threads
