-
-
Shankster replied to the thread Asking those who have done their own paint job at home.I did the same with a 71 Mustang years ago. It looked OK from a distance but the Maaco painter failed to get the low areas properly and... -
Shankster replied to the thread 2004 KJ 4x4 OME/Bilstein Lift.You might get lucky but when I did the same my front spring on the passenger side would hit the stock UCA under certain circumstances...
-
Shankster replied to the thread 4x4 shifting issue.I'm guessing the difference is that you have the Command Trac 4wd system (231 transfer case?) without part time 4wd and I have the Selec...
-
Shankster replied to the thread 4x4 shifting issue.I was assuming your problem was at the transfer case but it sounds like it's at the other end of the cable at the shifter? Is that correct?
-
Shankster replied to the thread 4x4 shifting issue.Hopefully you got it working, at least temporarily. The stealership will likely want $40 to $50 for a $2 piece of plastic if you buy a...
-
Shankster replied to the thread Engine swap.My apologies if my post came across as a criticism - wasn't meant that way. I don't think you did anything wrong or made a bad decision...
-
Shankster replied to the thread Front end Qs re new KJ.The KK clevis seems to be available here for $43.55 ea + shipping...
-
Shankster replied to the thread 4x4 shifting issue.I'm going off memory but if you locate the transfer case at the output of the transmission I believe the linkage is in the gap between...
-
Shankster replied to the thread Front end Qs re new KJ.I doubt anyone would make an aftermarket version but they do appear to be available new OEM at online Mopar stores, like this one...
-
Shankster replied to the thread Front end Qs re new KJ.That would be the clevis. I see they're still available new some places ($222 ea!!!) but I'd just get a used pair from somewhere west of...
-
Shankster replied to the thread Front end Qs re new KJ.My OME spring, Bilstein strut, RRO upper A-arm, locknut lift rides like a Cadillac compared to stock - parts were just over $1000 3 or 4...
-
Shankster replied to the thread Engine swap.Looks like we were typing at the same time - well said, lfhoward! I looked at Jasper engines but they were beyond my budget.
-
Shankster replied to the thread Engine swap.There are reputable engine builders out there who will send you a good engine and stand behind their product. I agree you need to do the...
-
Shankster replied to the thread 2005 Liberty Sport Parasitic Draw Issue.Make sure you pull your ignition key out when it's exactly at the "off" position. The ignition switches on these can wear out, allowing...
-
Shankster replied to the thread Toe Alignment Keeps Going Out.I had the same issue and fought it like you did. I finally replaced the steering rack which solved the problem. I kinda wish I had...
-
-
Loading…
-
Loading…
