andrew.jeep
New Member
"installed" MOPAR remote start in my wife's '05 liberty renegade today. it's not operating.
the directions were horrible - they mention wire colors on certain harnesses that do not exist - so i had to go by wire positions. am i missing something here? did anyone else notice this in the directions?
how do i know if i need a bypass box?
i'm a little confused and any info you folks can pass along will be a ton of help (wiring diagram, etc). the car still starts and locks, etc. but i could not get the remote start into any of the programming modes. i pressed and help the programming button for 10 secs, the engine light flashes, but i do not get an audible chirp from the horn/lights.
the directions were horrible - they mention wire colors on certain harnesses that do not exist - so i had to go by wire positions. am i missing something here? did anyone else notice this in the directions?
how do i know if i need a bypass box?
i'm a little confused and any info you folks can pass along will be a ton of help (wiring diagram, etc). the car still starts and locks, etc. but i could not get the remote start into any of the programming modes. i pressed and help the programming button for 10 secs, the engine light flashes, but i do not get an audible chirp from the horn/lights.