Hey ya'll-- wrecked my Libby two nights ago, sadly I have to part it out. Here's what I have for sale. When I get the vehicle back I will have pictures.
its a 2005 Renegade with 125k on it. Body parts are not good, so not much there. Drivetrain is great though, nothing tweaked in the wreck.
Aftermarket Parts:
OME HD Kit
2x TeraFlex bump stops (3")
6 conduit nuts, 3 per side for the clevis lift
1/4" top plate spacers (on top of the strut)+
JBA UCAs
JBA rear bump stops, trimmed to 2"
4x KJ isolators, 2 per side
All was purchased in March and is in good condition.
1000$ This saves you a ton of money!!!
Boilers Rear Gas Tank Skid Plate, just installed a month ago, good condition: $200
Rear Hitch + Shackle Receiver: $100
Stock Renegade wheels *decent* condition (scratches etc, no bends) with 245/70/16 General Grabber AT2s with 90% percent tread (installed December): $600
Rubicon Wheels *decent* condition: $400
Renegade Light Bar: $300
I believe that's it for aftermarket parts-- of course the rest of the jeep is for sale, including motor and trans and all that good stuff.
its a 2005 Renegade with 125k on it. Body parts are not good, so not much there. Drivetrain is great though, nothing tweaked in the wreck.
Aftermarket Parts:
OME HD Kit
2x TeraFlex bump stops (3")
6 conduit nuts, 3 per side for the clevis lift
1/4" top plate spacers (on top of the strut)+
JBA UCAs
JBA rear bump stops, trimmed to 2"
4x KJ isolators, 2 per side
All was purchased in March and is in good condition.
1000$ This saves you a ton of money!!!
Boilers Rear Gas Tank Skid Plate, just installed a month ago, good condition: $200
Rear Hitch + Shackle Receiver: $100
Stock Renegade wheels *decent* condition (scratches etc, no bends) with 245/70/16 General Grabber AT2s with 90% percent tread (installed December): $600
Rubicon Wheels *decent* condition: $400
Renegade Light Bar: $300
I believe that's it for aftermarket parts-- of course the rest of the jeep is for sale, including motor and trans and all that good stuff.
Last edited: