Robocody
Full Access Member
Hey all,
I'm thinking about designing and welding up some bumpers for my '03 KJ, but It is -15 out right now, and I'm not able to use my garage... I figure I can just draw the parts up now and have my brother do the assembly work in his shop. The only problem is that I have no clue about the mounting points used for the front and rear bumpers, and it's too darn cold and snowy (1.5 fee all around the jeep ) to go out there and measure at the moment.
Does anyone have the measurements off hand for the mounting points on a front and rear bumper? If so, that would be awesome... and I'll make a CAD template for the bumper and make it available to everyone. While I'm at it, if anyone has the dimensions for the mounting holes on the various skid plates, I can also draw up some CAD templates for those.
Thanks,
-Cody
I'm thinking about designing and welding up some bumpers for my '03 KJ, but It is -15 out right now, and I'm not able to use my garage... I figure I can just draw the parts up now and have my brother do the assembly work in his shop. The only problem is that I have no clue about the mounting points used for the front and rear bumpers, and it's too darn cold and snowy (1.5 fee all around the jeep ) to go out there and measure at the moment.
Does anyone have the measurements off hand for the mounting points on a front and rear bumper? If so, that would be awesome... and I'll make a CAD template for the bumper and make it available to everyone. While I'm at it, if anyone has the dimensions for the mounting holes on the various skid plates, I can also draw up some CAD templates for those.
Thanks,
-Cody