-
-
LLFX1 replied to the thread What did you do to your jeep today?.what are you expecting the charge on the spring compress to be ? I wasn't sure what was a good price for that.
-
LLFX1 replied to the thread What did you do to your jeep today?.So what your saying is it was easy so I should send mine your way to clean up nice like that. Those look good!
-
LLFX1 replied to the thread What did you do to your jeep today?.Must be a rabid squirrel
-
LCheck your upper and lower ball joints, they are the no1 cause of knocking noises & if ignored the wheel will fall off!!
-
LLFX1 replied to the thread What did you do to your jeep today?.The link for the front and rear go to the same page, can you post your front bumper link. thanks,
-
LLFX1 replied to the thread What did you do to your jeep today?.That is pretty sweet, I been looking for something similar for my Avy, but buying one pre built is so expensive. I haven't seen to many...
-
LYes the CRD springs are a bit harsh, so I recently changed to 2927 spring. It rides alot better and has better suspension flex with the...
-
LLFX1 replied to the thread What did you do to your jeep today?.What gets me is these car companies want to cut cost but they make so many stupid decisions when it comes to accessories, like you...
-
LOh no, not compressing these myself. :eek: I’m going to have them disassembled at a shop and put back together at a shop, where they...
-
LLFX1 replied to the thread What did you do to your jeep today?.you going to compress those your self? I picked up a pair I believe they are OME2790, depending on where you reference the part number...
-
LLFX1 replied to the thread What did you do to your jeep today?.does this ride hard with crd springs, what rear and front bumpers do you have. tire carrier looks different, off set, is that factory...
-
LI haven’t heard of anyone using them either. But I have stock CV’s and never had any issues. I have heard of people having problems with...
-
LLFX1 replied to the thread What did you do to your jeep today?.Did you consider or know anyone who has used those TrakMotive CV's for extended travel for lifts, they have them for the liberty models...
-
LJob done. Couldn’t have been easier. I wish I had bought the torch a long a long time ago! Also a 22 mm closed end wrench was important...
-
LLFX1 replied to the thread What did you do to your jeep today?.Thanks, when I couldn't find 07 listed I just happened to look there as I that is where everyone says to get the diff mounts if you need...
-
-
Loading…
-
Loading…
