Search results

I've successfully been able to continue keeping my wife's 2003 sport running. Well over 120k miles, been fine as of late, typical older car issues. Anyhow, need to get the suspension refreshed. Clearly this is a commuter, it isn't even a mallcrawler so no need for lifting or over the top...

my clutch does not seem to cycle, no cold air. seems like the clutch is bad, does this mean the compressor is as well? is this something worth getting in to myself? Sounds like at very least if I were to replace the compressor which includes a new clutch I need to have the system discharged...

like new condition, hardly used. Still have in original box and includes original paperwork. These clamp to your factory bars. Please email me if interested. (ridecannondale at gmail) Retails over 150 even on sale. Asking 100 plus ship. I am in Cleveland Ohio...

I have 4 Warn SDB 160 dual beam lights. These are great for spot and driving light, controlled by the switch. I also have the relay box and all necessary wiring and hardware to go with them. These look great on a rack, bumper, or anywhere. In great shape, these also have built in rock...

is this a common leak point? Seems the boot on the output shaft on the tcase is leaking. If this isnt common, would the tcase seals be bad? Looks like soaking coming from the boot but maybe the seal is bad and the tcase is just being covered in the slow soak. any past experience from...

the normal sound on the AC clutch isnt exactly quiet, but this has gotten loud. Seems the AC clutch chatters when it cycles on. Weird part about this, only makes this chatter when in R or D, if left in park it sounds like it always has. Any ideas, has anyone had this? Clutch going out?

has anyone done a compression test on a newer liberty engine, and then also on an older engine? I have to find some issue with my other vehicle and figured I would compression and vacuum test the liberty while I am at it. I have no baseline to go off of though, so just curious. I know 10%...

does the linkage ever need adjustment? I know it is cable drive, so maybe it gets too slack or too tight to not allow full movement?

there is a guy in las vegas on a land rover forum I am on that is selling a set of 5 moab wheels from a rubicon for 400 bucks. i always read about people wanting these, don't know if thats a good deal or not. let me know if anyone wants me to shoot him a msg

why is it that the sensor for the transfercase is a piece of crap? i have an 03, with the 231? transfer case, it is the hand selected one, I guess there is another. anyhow, every year, winter, my sensor goes bad, the transfer case is in 2hi but the part time light is on, if you raise the...

does the reservoir ever need to be bled on this thing? I dont think I have air, I am more interested in a fluid flush. havent looked at this one, anyone done this and care to share some tips? need some help as to what I should be looking for and doing to get fresh fluid in this bad boy

before I tackle this stuff on the jeep, couple questions. from reading here it looks like I have most covered, but just thought I would gather input. 1) drain front diff, simple drain and refill via plugs - 75w140 2) drain rear diff, drain and remove front casing, clean, replace with...

what is the situation with the sticky caliper on an 03 liberty? driver side rear caliper, some sort of recall, TSB, etc? I need to figure this out, it has been replaced once already. I changed all the rotors and pads yesterday on all four wheels. The pad on that sticky caliper spot was...

havent put the liberty up in the air with a floor jack and stands yet. i am used to using the pumpkin on my axles, then using the stands on the axle. is this acceptable, or should I be looking at alternative routes with the liberty? i am not that familiar with the liberty and the frame...

this has me. at slow speeds, and what appears to only be during warmed up operating temp, the jeep has a tick from what sounds like underneath the rear. I got under, checked drive shafts, they seem good, they turn just with the slack, but no more. I cannot figure out how to recreate it...

I am going to replace the pads and rotors on the liberty. The pads have been replaced whenever low, the rotors have not been replaced/machined (need to check my records) to my knowledge. From what I am reading, Napa, or Advanced, etc. has all four rotors and pads for about 200 bucks, for...

so I am past the 90k mark, I knew it needed some service, I've just been keeping an eye on things. I don't drive it daily, my wife does. I took it out and got dirty and worked it pretty hard. Don't think I broke anything, just some new scratches :) It isn't running all that smoothly...

well decided to check oil this morning. pull the dipstick, clean it off, push it back in, pull it out...there are some traces of whitish color..... I am going to go out and take some pictures and post it, I havent seen milky/creamy oil before so I will ask for some input here. I am crossing...

I searched, and read. Small leak evap system, did the gas cap thing, I cleared codes, etc. I cannot get this code to stop reappearing! I changed with a new chrysler gas cap, still does it. 3 warm cycles does not cause it to come back, it just comes back when it wants to. Only...

what would everyone recommend as a nice wax. I am planning on a last of the year waxing of my vehicles, and ive tried all sorts of waxes. I have hated some, others are ok, never really used one that I felt I needed to get more! I want to take care of swirls, but dont really need to worry...