I was trying to find one but didn't have one at the house. I was planning on getting some today and use them, there were several harnesses that were a bit loose.
I usually have to use 4HI whenever there is ice or a decent amount of snow <1". It does do better when I put some weight in the back but if conditions are as mentioned, I don't hesitate to put it in 4HI and pass everybody creeping along or off in the ditch.
After checking the butterfly, spring and cable from the outside, which all seemed to work smoothly I went back to the pedal and it was still binding. I pulled open the cover under the steering wheel and then tried the pedal again. Sure as s**t it was catching on a wiring harness. I secured the...
I searched on the forums but did not see any posts on this. Recently I have had an issue with the gas pedal sticking. It seems to only happen when flooring it and then letting off, it stays floored. I thought at first it was because of my big ol' boots but it has happened a few times now. I...
Ok, I was wrong on that one, the blend door actuator IS controlled all electronically. On the other hand I did end up having to change my blend door actuator seeing as I somehow did not get it set properly after I did the heater core. Low and behold with the new replacement (which you can only...
I just did the heater core on mine and the vac lines are the only thing that control the temp selector. The only possible idea I have, is that somehow the blend door actuator arm got flipped so that it is working in reverse. Not sure that is even possible, just a thought. Worse part is having to...
Got it figured out, he had a transmission sensor cable and an oxygen sensor cable switched, after routing the oxygen sensor cable probably it no longer reached to the transmission.
If it is the rear input seal it is much easier to change than the front. I do recommend using an impact on the drive shaft bolts to remove and install them otherwise you may hurt yourself (lesson learned)...
Ok, I got a buddy who just replaced his engine in his 06 Renegade. He did not mark the harness and plugs properly before he took it apart and my 03 Freedom does not have ABS and he has more plugs than I do. What we specifically need is close up pics of the 4 plugs on the wall by the battery and...
166,400 miles, started losing the rear passenger wheel bearing (funny sound when turning and you could wobble the wheel even though all the lugnuts were tight), made it the 25 miles home and got it changed. Had a lot of shavings stuck to magnetic strip in the rear pumpkin so cleaned it all out...
My daughter, whom I have been teaching to drive has a habit of only lightly pulling up on the handle which does not apply the park brake very well, and of course she routinely leaves it on. I have also noticed even after replacing the shoes and adjusting it, that it holds decent in reverse but...
Kansas
Hi all, I'm in Junction City, KS. I went out to the Tuttle Creek Off road park earlier this year. My KJ is not lifted yet and there was still snow on the ground (it was 55 degrees though). We had 8 vehicles, two with 6" lift pickups and they were stuck before I even got down the hill...
Front Diff Replace
REMOVAL
1.
Remove axle from the vehicle.
2.
Remove differential housing cover DIFFERENTIAL COVER.
Click to enlarge
DIFFERENTIAL COVER
1 - COVER
2 - VENT TUBE
3.
Push right axle shaft out of side gear RIGHT SHAFT IN SIDE...
The link helps explain some of it but as for my main question- when I buy or look for parts do I go with Sport, Renegade, or Limited because those are the only options ever listed at AutoZone or any parts store?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.