derekj
Latest activity Postings About
-
-
derekj replied to the thread Driver door handle issue.I would pull the door panel off and watch the levers/cables in the door as you operate the handle - looks like there is probably a... -
derekj replied to the thread Oil on plug. Chasing codes..Good on ya for pulling the motor out - makes the job much easier. Keep us updated!
-
derekj replied to the thread Check Engine Light with Code P0117. Doesn't appear to be overheating, and temp gauge seems to be working fine..A partially stuck open thermostat can flag coolant temp codes - how long does it take for your engine to warm up when driving it in the...
-
Cedar shingles, it was very important to my wife to have it match our house which was built in 1900. So we decided that's her baby and I...
-
derekj replied to the thread Still Going Strong.Looking good for 20 years old!
-
derekj replied to the thread What did you do to your jeep today?.Cool siding on the house - what is it?
-
derekj reacted to CherokeeLiberty's post in the thread What did you do to your jeep today? with
Like.
Break out the 460’s! -
Tried my hardest to get that O2 sensor out and … well, crap. The tool. Not a bad quality one either. Outcome = stripped. :rolleyes...
-
derekj replied to the thread What did you do to your jeep today?.I have a set of these Knipex pliers, they never loose ;)
-
-
derekj replied to the thread Almost stalling at idle, 2x random misfire codes + rich exhaust bank 1. Need direction..Try isolating the purge valve from the intake manifold - could be sucking fuel in through the vapor line.
-
derekj replied to the thread Oil on plug. Chasing codes..Up to you - are they noisy? What is the mileage on your engine?
-
derekj replied to the thread What did you do to your jeep today?.If you can get a proper O2 sensor socket that really helps and also removing it when the exhaust is hot helps.
-
derekj replied to the thread What did you do to your jeep today?.Diagnosed my inop a/c to a faulty low side pressure switch.
-
derekj replied to the thread Oil on plug. Chasing codes..I'm sure you would be able to install some used heads - personally I only like doing a job like that once but it is your decision on...
-
derekj replied to the thread Oil on plug. Chasing codes..Only problem with a used motor is you are possibly getting one that could have a potential valve seat issue down the road - I would go...
-
-
Loading…
-
Loading…
