Help my cluster is ducked up!!!
- Thread starter mag03kj
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
have you ever removed the neddles??
Atrus
Full Access Member
did you mess with any of the connectors when you removed it for the light bar indicator?
ya i did remove them and i'm thinkin now that it was a ducked up thang to do
.....i tried to reset them but cant even get close to what they need to be!no i didnt.
ya i did remove them and i'm thinkin now that it was a ducked up thang to do
reset them how?? I think you have to put them in the position that they are when the vehicle is off and make sure not to press down on them to hard.
ya i tried that put when i start it up and at idol the rpm says 100 and my speed gauge is off by like ten bc i can set the cruse at 25 and aint they suppose to set at 35?
I think the cruise is 30, do you have a gps that would tell you the speed?? That way you can compare and make sure
my dad does...i do that tomorrow and thats a good idea lol
yellocoyote
Administrator
I did that once. Had to use the scanguage to be able to set the RPM's back where they were supposed to be, filled the gas tank to full and then put that needle back accordingly, and set the cruise to adjust the speedo needle. Temp gauge usually sits at 1/2, so I fixed that one once I knew the engine was warm.
And yes - be sure to not press them all the way down.
And yes - be sure to not press them all the way down.
beartard
Full Access Member
Did you try holding down the reset button while turning on the ignition?
see the temp and the gas is right...just the damn rpm and mph
ya i tried..but nothing to get them back to factory seting
S1Loki
Full Access Member
can't talk to the local yards till monday and if they are open due to the holiday.
10-4 and thanks again
