Paul M
Full Access Member
:icon_mrgreen:
Last edited:
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I should also add that our Rig has four cross bars fitted.
Three on the factory roof rails and one bolted directly to the roofs sheet metal.
That way the loads are spread out over a greater area.
It turns out it's a self-tapping screw.
You must be registered for see images attach
I left the front as is and chopped a little off the back to even them up. I put a little spraypaint on the cut end and then drilled a small pilot hole for the screw at 1/4" back from the end.
Here is what they look like evened up with 2 5/8" of overhang. I also adjusted the spacing so that both bars are over the factory holes in the top of the roof rails:
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Sorry for the dbl msg...it's snowing and the internet flaked out.
Hey Ry, is the headliner any closer when you load up? :icon_mrgreen: