Search results

personally i like the 02-04 look that's why i have one. The 05-07 looks nice too with chrome accents. It grows on you. Now the new 08 look like a mini version of the commander which again should grow on you. All in all, it's the appearance and not so much with the equipment overall.

so are you saying i should change the 02 sensors then tjkj2002?

the diagnostic came back as low voltage on the TPS sensor. The "friendly" mechanic advised that problem can't be MAP sensor or a dirty throttle body at this point. He went on to tell me the TPS determines the shifting and gas/air ratio, something like that. Also because i don't drive my...

Engine light came on. But when driving today, it seem fine and now the light went off. I'm getting a computer diagnostic first to see if they can identify the problem. My car only has 34,000 km (21,127 miles)

Do you know if the Liberty has a air/flow meter? I didn't get any error messages. robert

rough idle yes, right now it's idling higher in neutral, about 1500 rpm. If I change gear to D, the truck lurches and shift down to 1000 rpm. Really odd, looks like i'll have to bring it to the stealership to diagnosis. As for the cruise control, I don't use it at all as I enjoy using the...

checked the other forum and didn't see anyone else have this problem. My jeep normally idles at 1000 rpm. Yesterday it creeped up to 1500 rpm at idle. When i engage into drive the jeep felt like pulling forward jerking as if i was pressing the gas and brake at the same time. In drive the rpm...

I recently have the same noise but when going over big speed bumps, it sounds like the front is rubbing something, as opposed to a squeek. The noise reminds me of a lowered car going over the bump. What i can't figure out is how would the sway bar bushings make that noise instead of the lower...

If the rear main seal is the same as my previous car, it's no big deal. It's just annoying that you have to top up the oil more regularly than never. It would cost you a great deal of $$ since they have to remove the bottom half of the truck to be able to access it. And even still, if they...

i too have them on my Jeep. The left arm conforms perfectly, but as for the right, the edge doesn't make contact with the window. Otherwise they seem fine, all new wipers are great until the rubber deteriorates. Haven't tried them on hiway speeds yet.

omg, that's like the dukes of hazzard scenarios. high flying action. What a way to torture that Jeep. Wouldn't want that on mine. fuji

I use regular oil and don't have any problems of foam. fuji

I've had no problems, i use a automatic payment plan. Useful website shows how much you owe still. fuji

Welcome and have fun. :-({|=

yes the instructs were somewhat misleading but I noticed that I had to program all the remotes including the original one in order to configure it. Not sure why but it does work and you save a ton of money by DIY. fuji

my friend, if it is the head gasket, your looking at spending lots of money unless you have warranty, and still it's up to the dealership to state whether warranty covers head gasket and the overhaul that comes with it. In general, if it is the head gasket, they will have to order a...

hope mine will be that easy.

why does the site come up as incomplete as opposed to unperformed. Incomplete sounds as if the Jeep recall can't determine if our vehicle needs the LBJ. What do you guys think?

if it's just the engine that is seized, is it not worth getting it rebuilt? At least with a rebuilt, you'll have warranty and it's like a brand new engine. fuji

best and cheapest way is just to spray graffitti black on it or use a black permanent marker. fuji