I had an alignment before the lift was installed but more then that is the lost height in the front I only have about 1.5 over stock in the front right now. And I would think it should be closer to 2-2.5 after it settles.
the lift just does not seem sturdy I went over a speed bump at 2-3 mph and the front nose dove I am worried if I take it wheeling the whole thing is going to break
This may sound dumb but I used my 4-lo today for the first time and it was really hard to shift out of, I was stopped and not moving and the shifter felt like it was locked and even as I pushed it down it would not budge I have a manual and the shifter was in neutral.
What do you guys think about the dana locker or the powertrax I want to put a locker in the front and rear but dont want to drill the housing which is required with the ARB air locker.
I was wondering has anybody had front sag after they installed there Rustys lift. I lost 1.5 in the front and am down to 34" from the ground to the bottom of the fender and the back is sitting at 35". I know they say it's going to sag but does this sound about right? Any hekp would be great.
CV Boot Update
I just wanted to let you guys know I had a different dealership put on a new CV Boot and it has gone 3 days without any problems. The tech said the band had slipped off the last one and dug a hole in the boot. Which caused the last one to go. As far as the first I think the shop...
Hey guys, i need your advice I just ordered new tires and wheels for my 06 libby. And I want to know if you guys think I am going to have problems getting them to fit without to much rubbing.
Crager Soft 8 16x7 5BS
BF Goodrich MTR 235/70/16
the jeep has been lifted 2 inces using the rusty...
I only put 100 miles on it when I noticed it and the shop said it's not covered because it's a road hazard issue. Plus I went to the jeep dealer to get it fixed and the next day it ripped again I dont know whats going on.
The lift was put in by a local 4x4 shop and I noticed alot of cv grease on the drivers side front wheel. And when I took the wheel off I noticed the CV boot had a tear on the top of it. The jeep has only been run on the road and only has 3500 miles on it.
I just put in the Rustys lift and within a week both CV boots ripped the jeep only has 4000 miles on it has anybody else had any problems with this happening
Hey guys I just wanted to let you know I put in the Rusty's kit in today and it went great I forgot to take before measurements but when I was done the Libby sat 35.5 all the way around it looks alot taller but I am not sure of the total lift gained. But I will say use the Rancho's in the back...
I would try just using a strut spacer from Rusty's thats what it's made for I have one on mine just for the ARB bumper. It will alow you to get a half inch of lift in the front to compinsate for the drop the bumper will cause
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.