-
-
JJeremy-WI replied to the thread CATACLEAN product. Does it work to clean your cats? Or will it kill them..I would expect an O2 sensor with a fault to be ignored and the fuel system to run in open loop. My 2006 was throwing the drivers side...
-
JJeremy-WI replied to the thread CATACLEAN product. Does it work to clean your cats? Or will it kill them..I would see about replacing the 02 sensor on the passenger side between the engine and the catalytic converter.
-
JJeremy-WI replied to the thread What did you do to your jeep today?.Good experience for him. The drivers side rear on mine was easy, the passenger side fought me even after turning back the auto...
-
JJeremy-WI replied to the thread no lights on night dashbord + right sidelights ( little white front + red rear ).It may be fuses 7 & 9 for the lights, I am sure they are red fuses(10 amp)
-
JJeremy-WI replied to the thread What did you do to your jeep today?.I bought a Dorman 938124 from rock auto, it wasn't the cheapest but it wasn't as much as local parts stores wanted. When putting a good...
-
JJeremy-WI replied to the thread Another No Crank No Start.When you bypass the relay does the engine turn but not start?
-
Junless you need 4wd any time soon, you can drive pretty much indefinitely with the front shaft removed.
-
JJeremy-WI replied to the thread What did you do to your jeep today?.They run fine without the front driveshaft, I had mine out for a week or so as I wanted to replace my starter and then noticed the rear...
-
JJeremy-WI replied to the thread What is this hose please? Jeep Liberty 2006 3.7L V6.Find out where that hose is connected to. I saw nothing like it on my 2006 and I replaced the front driveshaft and the starter a few...
-
JJeremy-WI replied to the thread Are the front hubs always "engaged"?.My 2006 is always engaged, I can jack the front wheel off the ground and the front driveshaft turns when I spin the tire
-
JJeremy-WI replied to the thread New Water Pump, Old Belt.Depending on how many miles, it might be time to replace belt and the belt tensioner. I got lucky when my belt tensioner bearing went...
-
-
Loading…
-
Loading…
