Is my intermediate shaft shot? Or does this extending out mean my differential could be damaged? I'm assuming I need to replace intermediate and cv on this side?
Checking if people can advise what I'm in for :(
Is my diff likely empty of gear oil?
probably not a major issue, most likely your shifter cable has popped off the transfer case lug
get underneath and see if you can find the control cable it likely is hanging off the transfer case, you can use a cotter pin from home depot to replace the plastic pin that broke off
I think this...
I recommend felpro gasket when you reassemble, had an early leak on a new water pump, good quality aftermarket gasket solved it. The felpro had almost 5mm of lip sticking out taller than the stock gasket and that all compressed when torqued down, made a big difference for very cold climate
I do have silicone wd-40 in the basement, going to take a look this week and follow up, I guessed it's not the resistor module as I didn't lose any particular fan level first, they just all cut out together when it happens
has anyone had an issue of the blower failing to run on any speed when the interior cabin is very cold (below -25c)
I've had this issue twice this winter, once it kicked on after driving a kilometer, and more recently it didnt kick on until I went over a decent bump in the road. This also...
this turned out to be it, I was a fair bit above min but it was triggering the light once the engine was on, not sure how it got lower, hopefully its just bulging lines somewhere
Hi folks, after things got a bit colder here im finding my e-brake light coming on somewhat randomly
at first it was on when the vehicle was started, more recently now it seems to flash on for a while after releasing the brake, after stopping
I've checked for brake fluid leaks and cant see...
In my experience you can use a lot more throttle than solid axle front ends can when it comes to approaching obstacles, but have to be careful about the front end lifting off and touching down while powering. I've found it to be a cross between a SFA Cherokee and a rally buggy. With good...
anyone able to advise which of these clamps would be for the lower rad hose on a 2006?
https://www.mcmaster.com/constant-tension-hose-clamps/constant-tension-spring-band-clamps-for-firm-hose-and-tube/
mopar is telling me a worm gear clamp is correct for my ride, but my current clamps are...
Mopar site is telling me this worm gear clamp is the right one for my 2006 https://www.buymoparonline.ca/oem-parts/mopar-lower-hose-clamp-6105105aa
but my current clamps are constant tension, im gonna be replacing tstat housing and lower rad hose soon and want to get fresh constant tension...
Ive heard of this happening from a weak fuel pump or from pressure leak in the fuel lines. In both cases air bubbles or vaporized fuel can cause start failure but only when the lines are hot, once the lines cool the fuel returns to liquidity
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.