Rear bump stop extension

[LucasD]

I am putting on my rro lift. Its the spacer lift in the rear. Ive seen people put hockey pucks as new bump pads with a spring lift, but I was wondering what people do on the spacer lift like this?

You must be registered for see images attach

I was thinking about taking it back apart and welding a plate over the top of the spacer for a bump pad. Is there a better way to go about this? Thanks

 

[lfhoward]

I am putting on my rro lift. Its the spacer lift in the rear. Ive seen people put hockey pucks as new bump pads with a spring lift, but I was wondering what people do on the spacer lift like this?

You must be registered for see images attach

I was thinking about taking it back apart and welding a plate over the top of the spacer for a bump pad. Is there a better way to go about this? Thanks

Most of us drill a hole in the lower spring perch and stack hockey pucks there, bolted down. A rule of thumb is one puck per inch of lift, because regulation pucks are an inch tall. You wouldn’t have to weld anything if the diameter of a hockey puck fits inside that hole in your spacer.

 

[Shankster]

Seems strange RRO wouldn't address the bumpstop issue in the design of the spacer - would be so easy to make that solid instead of hollow like it is. I think welding a plate on top of the spacer would probably work fine (if it's cast iron that might be a challenge). Another idea might be to fill that cavity with polyurethane sealant - you could do that without having to disassemble anything although it would take a few days to fully set up. The 3M Window weld stuff sets up faster and harder than standard polyurethane sealant so might be better, but it's a bit more expensive.

I like trailer door bumpers https://www.ebay.com/itm/144017104850 better than hockey pucks - they're cheaper and the "countersunk" depression for the attaching bolt means your upper bumpstop isn't getting damaged on the head of the bolt when you bottom out. If you need more height than one bumper provides I guess you could stack them but probably better to have a hockey puck on the bottom and a bumper on the top.