-
-
CCelticlady reacted to seafish's post in the thread Blower motor resistor replacement 4-wire set up with
Like.
^^^ That green one in your picture does NOT look like the right one… Not only is the plug wrong, but the screws are located in a... -
CCelticlady reacted to Shankster's post in the thread Will your factory jack do its job out on the trail? with Like.
For me the answer was no. I lost a tire on a gnarly trail and my factory mechanical bottle jack was too short to lift the vehicle (3ish...
-
CCelticlady replied to the thread My 2.5" done..Thanks
-
CCelticlady replied to the thread My 2.5" done..I built the bumper. I looked and looked. Could not find any that worked for me. They either required major frame modifications, removal...
-
CCelticlady replied to the thread Ball jointed sway bar links.I got these from Amazon USA. Today. 12-27-25 Spent the afternoon fitting them. They are not for a liberty, but will work. One stud is...
-
-
CCelticlady replied to the thread Need to replace my 2002 KJ engine.06. But as I understand it the selinoid bank is common to all of the gas 3.7 My research showed it above the valve body. Depending on...
-
CCelticlady reacted to JeepJeepster's post in the thread AC compressor keepers cycling even when AC is turned off. with Like.
On the 02-04, the compressor will kick on in both defrost positions.. On 05 and up KJ's, it will also kick on in the floor position...
-
CYa sometimes the interwebz just *****. Would it help if I told you that my 2005 KJ has the exact same pumpkin as yours and I just...
-
CCelticlady replied to the thread Rear differential skid plate.Ok. Its just that I have been told 50 deferent times its this or that. I don't know what to believe. The 8.25 is the better one...
-
CCelticlady replied to the thread Need to replace my 2002 KJ engine.Recently seeing a lot of 2002-2007 liberty's for sale on FB with dead transmissions. $1000. NW AR. My trans went out at 170,000. Its...
-
CCelticlady replied to the thread Rear differential skid plate.https://www.cherokeeforum.com/attachments/f67/384357d1501535309-dana-35-vs-8-25-smile-1.gif I have been totally confused by all the...
-
-
CCelticlady replied to the thread Rear differential skid plate.Yes. 1998 M1078 LMTV with a dump bed conversion. Short wheel base with the cab over. Good for navigating in tight spots. Air spring...
-
CCelticlady replied to the thread AC compressor keepers cycling even when AC is turned off..I don't disagree. Been turning wrenches sinch 9 years old. 70 now. Still doing it. Yes that surprised the heck out of me. This whole...
-
CCelticlady replied to the thread Rear differential skid plate.According to link of differential covers thats a 35. Not drum brakes. 2006 It is not original. It is a salvage rear end. As I remember...
-
-
CCelticlady replied to the thread Rear differential skid plate.What would be a good drop in limited slip or basic locker? I assume front and back must be done at same time?
-
-
Loading…
-
Loading…
