polomaan
Full Access Member
I was launching jet skis from a trailer and the back of the jeep probably went a little too far into the water. The trailer light connection got wet but it has a rubber sheath around it. The water may have been high enough where a good portion of the bumper was in the water. When I was stopped, I noticed that my right blinker light would constantly stay on if brakes were pressed (brake lights on). I thought it would go away after everything dried but now it's a week later and it still does the same thing. Every time I hit the brakes my right blinker light (and signal in console) lights up solid for as long as I hold the brakes down.
What do I need to do about this?
Thanks!
What do I need to do about this?
Thanks!