bjeffers83
New Member
- Joined
- Oct 19, 2021
- Messages
- 17
- Reaction score
- 1
My OME 731s gave me a whole 1 inch, ***. Where is my 2.5 inches?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
KK was only 18 inches new middle of hub to bottom of flare in front, now 18.25 ???18.25 hub to fender in front, have not installed front yet, only rear just today.
Rear was I think 19.5 ish, now 20.25
OME 731, Bilstein 5125 33-185552
No isolators besides the stock
If by extra you mean weight, the car is stock and empty besides a fishing pole or three.
Mislabeled springs? Should the 731 be 2 inches taller than the stock?
No one is asking about front springs. No one is asking about 4 different springs. I am asking about 2 specific springs. But thank you for chiming in on people who don't know what they are measuring.You can have 4 different springs that are the same height unloaded
but when on a vehicle give 4 different heights
it all come down to the diameter of the wire used, the compression rating built into each spring
we have ran into this hundreds of times when people start measuring things without knowing exactly what they are measuring
in the case of different springs, how each is rated , etc
all OE springs are basically the same each rated at 310 lb for the fronts which by the way to low, should of been 340-345 lb
Like what the actual **** is the point of this message? Talking down sarcastically over a 1/4 inch in the FRONT when trying to find a whole TWO inches in the back. What is wrong with you? Or should I put more question marks to show superiority ???KK was only 18 inches new middle of hub to bottom of flare in front, now 18.25 ???
where did you come up with that part number for rear shocks ??