installing light bar/roof rack need help

[Whitee]

ok I have an 03 liberty and I just put on my rack ( going from GA to PA tomorrow) and I have a light bar on it. what is the best route from roof to inside which im sure is drilling a hole through, and from inside the cab to the engine bay???:shrug:

 

[profdlp]

Go down to page 5 of 10 on the pdf (Step 16) and you'll see the OEM method like the Renegade lights use:

http://http://site.justforjeeps.com/guide/82206126AB.pdf

EDIT: Once the wire is inside you can use a Torx wrench to pull the grab bar an inside pillar cover. After that the wire is concealed behind the dash.

 

[Whitee]

thanks but for some reason the link isn't working

 

[tommudd]

Run wire from light bar under the moulding for the door/ winshield, comes off with 3 screws I think it is and wires can be run under it, down to the cowl, under it to engine department, very easy takes just a few minutes , no drilling and works
Assuming you don't have the Renegade ligt bar but some other attached to the roof rack

 

[profdlp]

thanks but for some reason the link isn't working

I fixed it. The forum added an extra "http:\\"

 

[CobraNutt]

Thanks for that pdf! I've been looking for something like that. I'd like to adjust mine a bit and haven't torn into the lightbar to see how to do it yet. Nice to have pictures of everything in there!

Sent from my mystical handheld gizmo.

 

[profdlp]

Glad to be of help. :favorites13: