Atrus
Full Access Member
Sorry everyone, I know it's the SAME question, but I don’t have the SAME lift
I am lifted slightly - 1.75" in the front via a Rusty's .75" spacer, and 1" in the back via 2 extra isolators. I can also do a 3/8” Clevis in the front, provided I can make sure there’s a way to level the rear back to it. Right now it’s got a very slight forward rake, less than stock.
So, if I were willing to pound the pinch weld, what would be needed in the front of the flare to fit a 75 without rubbing (if it's even possible)? I am cool with heating it up and pushing anything in, but I'd prefer not to cut on my '07.
I’ve checked the tire chart, and it seems like it says 1.5” would result in no rubbing? FWIW, I am looking at General Grabber AT2’s.
Sorry for the SUPER REPETITIVE question, I'd appreciate your experience/input.
I am lifted slightly - 1.75" in the front via a Rusty's .75" spacer, and 1" in the back via 2 extra isolators. I can also do a 3/8” Clevis in the front, provided I can make sure there’s a way to level the rear back to it. Right now it’s got a very slight forward rake, less than stock.
So, if I were willing to pound the pinch weld, what would be needed in the front of the flare to fit a 75 without rubbing (if it's even possible)? I am cool with heating it up and pushing anything in, but I'd prefer not to cut on my '07.
I’ve checked the tire chart, and it seems like it says 1.5” would result in no rubbing? FWIW, I am looking at General Grabber AT2’s.
Sorry for the SUPER REPETITIVE question, I'd appreciate your experience/input.