Search results
-
Need QUIET Tires Real Bad, Any Suggestions?
I went through 2 sets of destination AT's on my 07. They were a quiet tire at first but after I got about 20,000 miles or so on them they would get loud. Drove me nuts for a while because I was convinced it was a wheel bearing or something else mechanical. Put a new set on and was just as quiet...- 07 liberty
- Post #5
- Forum: Tires / Wheels
-
HVAC stuck (mostly) on defrost
I had a similar problem with my 07. Air would only come out the defroster vents. Opened hood and found a vacuum line closer to drivers side running horizontally along the fire wall that had sagged a bit and melted a small hole in it. I spliced it and put a plastic tube inside each spliced end...- 07 liberty
- Post #15
- Forum: KJ General Discussion
-
noob alert!
My 07 had electronic throttle. No cable. Sent from my SCH-I535 using Tapatalk 2- 07 liberty
- Post #3
- Forum: Introductions
-
Misfire
The issue with the heads in the 3.6 jk is in the 2012 model. Sent from my iPad using Tapatalk- 07 liberty
- Post #22
- Forum: KJ General Discussion
-
How long will a typical Jeep Liberty engine last?
120000 on my 07 when I traded it. I was original owner. Only engine related issue I had was the water pump went out about 70000 miles. Otherwise ran as good as the day I bought it. Sent from my SCH-I535 using Tapatalk 2- 07 liberty
- Post #83
- Forum: KJ General Discussion
-
Headlight Bulbs Poll
I used silver star ultras in mine for a couple years until i got tired of changing burned out bulbs and switched back to regular halogen. Sent from my iPad using Tapatalk- 07 liberty
- Post #3
- Forum: KJ General Discussion
-
2014 Jeep Cherokee Pics
Actually the more I look at it the more I am liking it. Fitted with a pentastar and 9 speed automatic and 4wd could make it a fun vehicle to drive. Not sure how much you could modify as far as tires or lifts though Sent from my Samsung Galaxy s3 using Tapatalk.- 07 liberty
- Post #68
- Forum: Jeep News
-
Steering column height locking lever
Took mine in to see what dealer could do about it and was told I would need to replace the steering column. Sent from my Samsung Galaxy s3 using Tapatalk.- 07 liberty
- Post #2
- Forum: KJ General Discussion
-
What did you do to your jeep today?
After 6 years with my 07 liberty I traded it in today for a 2013 black wrangler. Kind of bitter sweet. Was like losing an old friend. Sent from my Samsung Galaxy s3 using Tapatalk.- 07 liberty
- Post #1,156
- Forum: KJ General Discussion
-
2014 Jeep Liberrty debuts at New York Auto Show in April
Looks like its time to buy a wrangler when I get rid of my liberty this summer. Sent from my iPad using Tapatalk- 07 liberty
- Post #2
- Forum: Jeep News
-
Got some snow
Nice pics. Was just at Goose Island this morning. Sent from my iPad using Tapatalk- 07 liberty
- Post #9
- Forum: Post Your Liberty Pictures
-
Highest Mileage Thread
113,000 on my 2007. Minor repairs so far like windows regulators x 3. Water Pump. Had my rear end rebuilt but that's because the local jeep dealership forgot to put any fluid back in after I had rear backing plates replaced. All fixed on their dime but they had me driving a PT cruiser for a few...- 07 liberty
- Post #19
- Forum: KJ General Discussion
-
07 liberty dies at startup
Had a similar issue but hasn't happened for a while now. As soon as it would start it would Immediately shut down. Apparently that happens when the sensor in ignition switch doesn't read the chip in the key. Sent from my Samsung Galaxy s3 using Tapatalk.- 07 liberty
- Post #4
- Forum: KJ General Discussion
-
What did you do to your jeep today?
Had cv joint replaced on my front driveshaft. After running without the front driveshaft most of the summer, it feels like I'm driving a Jeep again. Sent from my Samsung Galaxy s3 using Tapatalk.- 07 liberty
- Post #929
- Forum: KJ General Discussion
-
Front driveshaft
Sorry I should have worded my post differently. Has any one had any experience good or bad with an aftermarket driveshaft cv joint when every jeep dealership says the shaft has a non replaceable cv joint. Sent from my Samsung Galaxy s3 using Tapatalk.- 07 liberty
- Post #8
- Forum: KJ General Discussion
-
Front driveshaft
How well do they hold out after being replaced? Sent from my SCH-I535 using Tapatalk 2- 07 liberty
- Post #6
- Forum: KJ General Discussion
-
Front driveshaft
Has any one replaced just the CV joint on the transfer case end of drive shift? How hard was it? How is it holding up? Where is a good place to get the part? Was just going to replace the whole drive shift but plan on trading it in this spring so just need to get through another Wisconsin...- 07 liberty
- Thread
- Replies: 14
- Forum: KJ General Discussion
-
A/C Problem
Had the same problem. After looking under hood I found a vacuum line had come out of bracket and dropped down and melted. Look at vacuum line that runs horizontal along top of firewall. Sent from my iPhone using Tapatalk- 07 liberty
- Post #2
- Forum: KJ General Discussion
-
Cruise Control Strange Issues
A few times my cruise wouldn't come on. I don't how I discovered this solution but now when it happens I briefly beep horn and then i can turn my cruise on. No idea why. Sent from my iPhone using Tapatalk- 07 liberty
- Post #5
- Forum: KJ General Discussion
-
Rear Control Arm Recall - 06/07's added
Had mine done yesterday. Had appt at 8 am and was done at 9. You can also check for open recalls for your Jeep by going to Jeep.com to the owners section and look for tab called recalls and type in your Vin number. Sent from my iPhone using Tapatalk- 07 liberty
- Post #10
- Forum: Technical Service Bulletins and Recalls
Latest posts
-
-
Rear windshield on 06' Liberty won't close and lock in most of the time.
- Latest: cruisingram2000
-