Recent content by RenegadeK

So I finally got my lift and rock rails put on this weekend and I'm itching to try it out. Anyone planning to go to Uwharrie or Gulches (in the carolina's) on memorial day weekend? Sent from my PC36100 using Tapatalk

Finally got it taken care of, threads were damaged on the end of the bolt which in turn damaged threads on the nut as well slightly. Got to the other side and as I disconnected the sway bar the bushing came apart. So I guess I'm driving with the front disconnected until I get another one in...

The nut isn't on far enough to get the socket on to the end, I will try clamping though. Sent from my PC36100 using Tapatalk

Been trying to install my frankenlift and I finally got the first corner almost put back together.but I cannot tighten the but on the upper arm, the ball just spins. Any ideas on how to get it to tighten? I have tried using 2 ratchet straps and a pry bar to apply downward force and it still...

I greased it, but never done before. Used the measured amount of grease that came with, squeezed it around the bearings on both sides just wonder if I should have tried to force the grease in deeper than I did Sent from my PC36100 using Tapatalk

So just got done installing my new drive shaft cv joint. Drove around a few blocks got up to about 30 everything seemed fine, crawled under to check it out. The cv seemed a bit hot got that short of a drive. Not too hot to touch but too hot to hold my hand there comfortably. Is this normal...

Iirc just regular hex head bolts. I usually don't even bother with a ratchet.just need the right size wrench, don't remember which size exactly. Oh, if you have trouble with rear rotors you may have to do something with the parking break to release the shoes not sure how to explain that process...

sorry to hear, that really *****, glad to hear she is ok though. that being said i could take a few things off your hands. bump stops rear hitch possibly light bar... If i were local, i would take the tires too, but SC is too far for that.

I stopped looking at the price ... Lol Sent from my PC36100 using Tapatalk

may be a little early to ask but, anybody planning anything for memorial day weekend? Either Uwharrie or Gulches, i think those are the only ones that are fairly close by ( still 4 or 3 hour drives from charleston) think i should be able to get my lift and everything installed by then and...

Thanks, I tried calling first got no answer, thought they had just closed for the day. Gonna order in a couple weeks but dont want it to take too long. Wanna be ready be memorial day weekend Sent from my PC36100 using Tapatalk

Just out of curiosity, and i dunno if this answer is already posted or not. for those of you who have ordered a Frankenlift, what was your average wait time to receive the product? Shipped the day, or day after you ordered it with 3-5 days transit? or did it take a week or two for it to get...

Yea I found a bunch done on tj's but didn't know if I had to drop the trans on the liberty or not, but I did get it to work. It looks like the breather is too far forward to access from inside the vehicle. But using a screwdriver and a hammer I was able to pop the metal cap off, and I did have...

thought I would post this in case someone else had the same issue. On my 03 liberty with the manual transmission (nv3550) there is no breather tube, just a cap on the top of the trans. Forward of the shifter, and towards the passenger side. I read elsewhere that someone was able to pry off the...

thanks! 70 dollar fix, much better than ~400 or 170 nana.gif now i just wish i would have seen this a couple days ago before i spent the 60 dollars for a new rear wiper motor. oh well.