Recent content by ktmmark

same as my 2004 was doors were just rust not through so easy repair, you could easy make a repair patch for the sills

Hi i just replaced my rockers, is it the rear section or all the rocker thats rusted pictures will help,as they are a simple shape its easy to make a repair section. I went overboard and cut my outer rocker's off and had 3mm thick galv steel ones fabricated look factory and good for 20 years +...

2004 so should be ok and car runs well so egr valve working ok time will tell :)

Going to blank the vacume on the egr and see how it runs for a week or 2 its the Uk spec 2.8 interested to see the mpg figures to and from work .has anyone else tried this :gr_grin:

They do seem to holding up well,hope i dont see one on hack n pack on utube ha ha the amount fo rust some of the American cars have is unbelievable as it can't get that bad here due to strict mot (inspection) law's every 12 months

sounds like the uk and us where they salt are about the same,love this jeep so going the extra mile to help it against rust

Was wondering how well the kj holds up against other cars for corrosion and where the kj suffers .would give us a heads up where to ad protection and extra cleaning . Here in the uk salt has attacked the rockers (blistering) surface rust behind the rear plastic arch liners and rust on the...

Thanks for the link,thats very handy didn't now about the torque converter being different ,why would they do that The cambelt on my 2004 is every 62,000 so was done a few years ago

Yes I am fully qualified mechanic of over 30 years, i am also an MOT tester (think you call it something else in the US) Here in the uk cars are tested every 12 months and all repairs to rockers chassis or structural arias must be welded repairs so no fiberglass or bondo allowed :icon_mrgreen:

well i brought my jeep Cherokee (as its called in the uk) 2.8 crd with some faults (got it cheap) first job was to fix slight blistering at the rear of the rockers, so used this as an excuse to make 3mm thick rock sliders and must say I am very happy with them :) next job was the heater fan only...

the motor in full [/URL][/IMG]

Picture of the 3mm thick galvanized rockers put a trim on to look factory realy happy with them :) [/URL][/IMG]

My jeep is mint also was just the rear of the rockers,so just thought do it as it will only get worse and make it better and stronger than original. did it over a weekend and the end result looks spot on. will post a better picture when I get the chance I also waxoiled the entire car rockers...

note just a few blister on the outside [/URL][/IMG]

[/URL][/IMG] the rust inside when I cut the rocker out