Recent content by Jacob789456
-
03 3.7 wont runn sat for 2 years
My KJ sat for 6 years 11 months without running. Change all the fluids, that is my recommendation. My OEM fuel pump went bad while it sat, it was completely varnished up. They are simple to change through the access door under the back carpet, and while you are in there, change the so-called...- Jacob789456
- Post #7
- Forum: KJ General Discussion
-
AC problem
It should cycle much, much longer. It could be that your system has a leak and has lost enough pressure to cause the low pressure switch to disengage the compressor clutch to prevent system failure. Ambient temperature has a significant effect on AC system pressure and can be why it only works...- Jacob789456
- Post #2
- Forum: KJ General Discussion
-
-
how hard is this to fix?
Depends, how bad is it running? Do you have a blinking check engine light? It is never good to run the vehicle while it is misfiring, however, if it is running reasonably, just don't beat on it and it will be okay. If it is seriously stumbling, hesitating, stalling, etc.. Do not drive it, as not...- Jacob789456
- Post #4
- Forum: KJ General Discussion
-
how hard is this to fix?
If it is just a simple ignition coil replacement. All you have to do is figure out which coil has failed (either by the code, by the misfire, or by swapping what you think is a bad coil with a known good coil), and then remove the coil (10mil bolt and it pops off the spark plug), and replace...- Jacob789456
- Post #2
- Forum: KJ General Discussion
-
Need Urgent Help with MAP problem
Hi all, Thanks in advance for any and all assistance. Tonight after driving my Jeep all day, perfectly fine, I got in it to drive up to the store and it barely wanted to start. It stalled 3 times, then ran extremely rough with plenty of backfiring, surging, and bogging, so I parked it. I drove...- Jacob789456
- Thread
- Replies: 2
- Forum: KJ General Discussion
-
ID this please - from rear differential
Well I would say there is probably more hidden damage if you ran it without a spider gear A) from the ring gear impacting the loose spider gear, and B)from the cross-pin running without support from one end. I can not tell what that piece is. Is it a hard metal piece, or is is a big piece of...- Jacob789456
- Post #2
- Forum: KJ General Discussion
-
2002 Liberty Part Out.... Pics of Everything. I may have what you need!
4WD sold! Will be creating a 4x4 conversion thread shortly- Jacob789456
- Post #47
- Forum: For Sale Forum
-
2002 Liberty Part Out.... Pics of Everything. I may have what you need!
99% sure I will buy your 4x4 conversion kit. I got a free quote on freightquote. I put it in as 2 40"x48" pallette's with a total combined weight of 750 pounds, shipping to a carrier terminal in San Diego. Quote came to 427.99 on UPS. Anything around this price for shipping will work just fine...- Jacob789456
- Post #43
- Forum: For Sale Forum
-
2002 Liberty Part Out.... Pics of Everything. I may have what you need!
You may have a complete sale on the complete 4x4 conversion kit. Can I please get a freight quote to a freight distribution center in San Diego, CA. I will even drive to Los Angeles or anywhere south of LA if it is cheaper! Thanks! I've been waiting for this to come up for a while! Also it looks...- Jacob789456
- Post #42
- Forum: For Sale Forum
-
Power Steering Pump Failed after line replacement!?? TJKJ!!
Well I installed the piston the wrong direction and re-did the job this morning. I have steering now, but now the pump groans really loud. I bled the system, but it is still groaning very loud. Anything I should do/check? It is full of new ATF+4- Jacob789456
- Post #2
- Forum: KJ General Discussion
-
Power Steering Pump Failed after line replacement!?? TJKJ!!
Hi all, I want to apologize for all the problems I have posted questions for lately. I have time to work on the Jeep now, so all the projects have begun before summer wheelin'! Today I replaced the high pressure power steering line. When doing so, when I went to remove the brass compression...- Jacob789456
- Thread
- Replies: 1
- Forum: KJ General Discussion
-
Front Bumpstop
wedge it in there enough to hold, then go take the jeep out and "bottom it out", the a-arms will push them into place! Sounds bad, but it worked for me!- Jacob789456
- Post #9
- Forum: KJ General Discussion
-
AC Repair process-TJKJ2002, please check my logic!
I wanted to check with y’all about the steps to recharging the KJ’s ac system. So my KJ was in a frontal collision in 2004, and sat in a shop’s yard for 7 years before I bought it and rebuilt it from essentially the ground up. One thing I never did was repair the AC system, and because the...- Jacob789456
- Thread
- Replies: 1
- Forum: KJ General Discussion
-
Remote Start Questions
Thanks for the help, I guess the last question would be, what transponder bypass would I need due to my Jeep having the Sentry Key?- Jacob789456
- Post #5
- Forum: KJ General Discussion
