Recent content by Cooker69

I couldn't get ngk so I had to buy champion plugs. Are they garbage? These were the old plugs

Thanks for the reply tommud. I just moved #6 to #1 cylinder that was it. Still getting random misfire. I was getting #6 before and now in 1 position it seems to be fine so old coil should be good? It actually seems to have lots of power up a hill. Rough idle on idle but smooths right out on...

Forgot to mention that its a 05 liberty with the 3.7

Having po 300 misfire code. Also had po 306 as well. Replaced #6 coil pack. Still getting po 300. Seems to run good but gets a little shaky at idle. I replaced all spark plugs. Noticed today a bit of white smoke at start up then went away? O2 sensor perhaps or a possible head gasket going? Any...

So I finally got to have a better look at the plug. Once I took off the electrical tape the plug fell right off. Wires were broke but looked perfect. Re sodered the wires and put back together. All fixed up! Thanks everyone for all your input it was greatly appreciated. Dean.

OK and that splice runs into the middle of the bottom of vehicle?

It's an 05 with the 3.7 4x4

I've looked but the wires connect to another group of wires. Can they be disconnected there? It's about a foot long to the other group of wires.

Checked wires on rear diff could not see anything wrong. Changed speed sensor and still no speedo. Could it be input or output sensor on ******?? Help help help! Feel free to offer any advice. Dean.

Any idea the # of the wiring kit and what it's called tommudd?

Follow wiring from plug at diff? Thanks tommudd

My cruise will quit working and my speedometer becomes erratic? Is this the sensor on top of the rear end? Hard to change out? Thanks, Dean.