Latest activity
-
Today I bought a 22 mm wrench and a Bernzomatic torch with the yellow MAPP gas canister. I will no longer be asking nicely. o_O -
Nnlsleal reacted to kjkotlar's post in the thread All aluminum radiator for jeep liberty kk 08 with
Like.
I did replace the plastic radiator in my 03 KJ a little over a year ago, with an all aluminum one that I found on either ebay or amazon... -
discogypsy posted the thread When I put motor oil in my 02 kj ,what's the plastic piece? in KJ General Discussion.I put engine/motor oil in my 02 kj liberty for my 1st time and noticed a piece of plastic, kinda long,has a flat top with a lil handle... -
Aatikovi replied to the thread Rear suspension or axle clunk when getting on or off the gas..Ok, after 9 years it may have changed. Were they made in the USA then?
-
Hi, I'm the owner of a 2006 3.7 4wd KJ Liberty. It has 335,000 miles on it, so just getting broke in. I've got a couple things to... -
NGot the new starter in Bert. All is well. Up and running on the factory drive train with 300k miles on it. Kids bought the wrong one...
-
What the marks on the temperature gauge represent. Normally it should run very close to the 176 deg. mark. Just slightly below the... -
Hi, I'm the owner of a 2006 3.7 4wd KJ Liberty. It has 335,000 miles on it, so just getting broke in. I've got a couple things to...
-
KJowner replied to the thread Rear Upper Control Arm Torque Procedure.You are quite right for normal bushes, unfortunately when they designed the upper arm they put the bushes in the wrong plane for some...
-
kjkotlar replied to the thread All aluminum radiator for jeep liberty kk 08.I did replace the plastic radiator in my 03 KJ a little over a year ago, with an all aluminum one that I found on either ebay or amazon... -
WWDiesel replied to the thread CRD running hot?.What the marks on the temperature gauge represent. Normally it should run very close to the 176 deg. mark. Just slightly below the... -
-
is this turning into a show off your IRO?... Or did I totally miss the social que?
-
BHi, I'm the owner of a 2006 3.7 4wd KJ Liberty. It has 335,000 miles on it, so just getting broke in. I've got a couple things to...
-
u2slow replied to the thread Rear suspension or axle clunk when getting on or off the gas..My invoice from 2016 says I ordered 2 units. Don't recall having any extras. Good luck -
CI plan on replacing my rear upper control arm this week and I was looking over the factory service manual on how to remove and install...
