Latest activity
-
Oosbro168 replied to the thread Suggestions for A/C clutch?.I got the china clutch works good been about 5 years now
-
Oosbro168 replied to the thread Suggestions for A/C clutch?.
-
Do you have room to hammer your torx bit driver on the stripped screw? If so, you can try using a piece of tin foil. Fold it so you... -
CCheddarGau reacted to CherokeeLiberty's post in the thread What did you do to your jeep today? with
Love.
It can’t be tight if it’s liquid… -
Here's the one I bought for my 04 with the factory Sanden compressor... -
N:facepalm:
-
BBigMopar440 replied to the thread Suggestions for A/C clutch?.Here's the one I bought for my 04 with the factory Sanden compressor...
-
lfhoward replied to the thread What did you do to your jeep today?.Looks like I may not have time to get to this until the weekend. But I will post the results. I will try not to burn down my Jeep. -
SYes, it will work fine on a stock height truck as well.
-
JMichael2006 replied to the thread Rear Upper Control Arm (Boomerang).Yes, it will work fine on a stock height truck as well. -
DDr. Pluh replied to the thread CRD running hot?.I just checked the temperature with a obd scanner and its 77°c/170F
-
Thanks, I will switch to the OME 2731 springs in the rear. Yes, the top spacers are for a little extra lift in the front. I had read... -
Hec In Omaha replied to the thread Remove stripped Torx from EGR.Do you have room to hammer your torx bit driver on the stripped screw? If so, you can try using a piece of tin foil. Fold it so you...
-
T2008 Liberty 3.7. been getting a P1404 (EGR not closing). Runs fine, though once in a while I get an extended crank to start. I went to...
-
I purchased them on Amazon but were shipped from China. Took about 10 days. https://amzn.eu/d/4EwfBUi
