FlyinOrange
New Member
Hey all,
I noticed a burning smell after stepping out of the beastie this morning at work. Looking underneath, there appears to be fresh oil spray (with dirt) on the surfaces facing the midsection of the shaft (drivers side). Looks like oil was dripping onto the shaft and getting sent everywhere.
The front pinion seal looks clean, so it is not oil out of there. I had both the seal and the shaft proper both replaced by a ****** shop mid last week and I am wondering if the jacking up and banging to get the old shaft out might have been enough to put the old VCG over the edge?
Thanks in advance for any thoughts.
I noticed a burning smell after stepping out of the beastie this morning at work. Looking underneath, there appears to be fresh oil spray (with dirt) on the surfaces facing the midsection of the shaft (drivers side). Looks like oil was dripping onto the shaft and getting sent everywhere.
The front pinion seal looks clean, so it is not oil out of there. I had both the seal and the shaft proper both replaced by a ****** shop mid last week and I am wondering if the jacking up and banging to get the old shaft out might have been enough to put the old VCG over the edge?
Thanks in advance for any thoughts.