engine stalling after starting

[nero2]

Čo môže spôsobiť zhasnutie motora po naštartovaní? Iba studený motor. Auto naštartuje a keď sa chcem pohnúť, zhasne. Chvíľu počkám a potom naštartuje. Pri pohybe sa nezhasne, iba keď sa chcem pohnúť z miesta nízkou rýchlosťou. Je to Jeep Liberty KJ 2.8 CRD z roku 2005. Mohla by to spôsobovať chybná škrtiaca klapka?

 

[KJowner]

Sorry you need to post in English, I'm not sure what language this is?

 

[DadOSix]

What can cause the engine to stall after starting? Only a cold engine. The car starts and when I want to move it stalls. I wait a while and then it starts. It doesn't stall when moving, only when I want to move from a place at low speed. It's a 2005 Jeep Liberty KJ 2.8 CRD. Could this be caused by a faulty throttle?

Post is in slovak per google translate

 

[Ian Glass]

Not sure if you sorted this problem!
1) Check that your diesel filter is clear - or fit a new one.
2) Make sure all the air is primed out of the filter housing - 13mm brass bolt is the bleed screw!
3) Make sure the injector pump - CP3 is delivering full pressure.
4) Check that the FQS (Fuel Quantity Solenoid) on the CP3 pump is not cutting off intermittently - this causes the motor to cut-out 30secs after starting!
5) Faulty sensors can also cause problems - some when the motor is cold and some when it's hot(cold in your case).
That should give you some pointers as to where to start looking.

 

[Geralt]

I had the same problem,
for me it was the fuel metering solenoid valve on the CP3 pump.
The car starts fine and stalls after a few seconds.