Search results

The oil pan on my 2003 is getting pretty corroded despite spraying with anti-corrosive over the last few years at each oil change. I know the shop manual simply states to "remove motor", but I have also seen other methods where the cross member is lowered along with the differential. Does...

Have a 2003 Liberty with the Chrysler coolant that was put in when the heater core was replaced. Coolant is a little low and I want to top it off. I have some BMW Coolant that is a HOAT formulation, which is what Daimler used in Jeeps when they owned them. Has anyone mixed these two coolants?

Does anyone have any diagnostic methods for the heater control that is on the dash? Just had the heater core replaced and now get warm air not hot. Did the calibration procedure and got hot air for a while but now it is only warm again. It is either the heater control or (I can't bare to...

Just had the heater core replaced. Heat is not as hot as prior to the replacement. I know the blend door is moving but am wondering if there is something blocking its full motion to the heat side. I have a boroscope that I can look in there but am not sure how to get into the door. Does...

Just had the heater core replaced. The A/C compressor isn't running when I put it on A/C. Its 41 degrees and rainy (cold & damp). Does anyone know if there are temperature/humidity parameters where the PCM won't allow the A/C compressor to run? I wanted to test it to make sure they...

Getting ready to install the Steiger Performance window regulator part and have been reading up on the door disassembly and reassembly. There is a water dam or as some call it vapor barrier under the trim panel. Service manual states to make sure it seals good. Is this part normally replaced...

My daughter came over tonight and her left rear window wouldn't go up. When I looked at it the spiral cable was sticking out of the door where the latch is. When the switch was operated, the cable retracted back into the door. Does this sound like the same problem that the Steiger bracket is...

Has anyone installed one of these? Wondering if it is more reliable than the CV setup from the factory. Jeep Liberty Conversion Shaft - Performance Industries

Don't post too often here but have been doing some searches. We came home yesterday afternoon to a nice river of tranny fluid in the driveway. Upon inspection, the transmission pan has rusted through. I have a few questions I am hoping someone can help with. First, it appears that Jeep put...

I just picked up the Haynes manual, which as usual is lacking in information. I am looking for the torque value for the front differential fill and drain plugs and the transfer case fill and drain plugs. Thanks

Hi, New to this forum and Jeeps. My daugther has an 03 Liberty that I now have up on blocks. It appears the rear caliper pistons stuck and ground the pads right into the rotors. Does anyone have the service manual that can provide me with the torque value required to install the rear...