Search results

  1. M

    Change Oil Message

    About 2000 miles before I was due for an oil change, everytime I started my Jeep a message would come up on the dash saying "Change Oil". I continued to drive and change my oil at my normal interval. But now after I changed my oil, the message still comes up. Do I have a bad sensor? This was...
  2. M

    Brush Guard Mounting

    Do I need to take the front bumper off to mount a brush guard?
  3. M

    Brush Guard Mounting

    I am trying to build my own brush guard for my ‘11 KK. Where are the best mounting spots and how would I mount a brush guard to my Jeep? Thank you for any help!
  4. M

    Problem, "No Fuse" error message

    So here is what I found out, My battery was weak and I had it replaced, I forgot to ground out one of my wires from my new stereo so even though the draw was low the weak battery just failed very quickly. And about the error message I was receiving (no Fuse), I took the positive and negative...
  5. M

    Problem, "No Fuse" error message

    I havent had a chance to test all of my fuses with a multimeter and I am going to go get the battery tested today, but I think the problem might be partly my new stereo because yesterday I charged my battery all the way up then I unplugged the stereo and waited all night. My jeep started up fine...
  6. M

    Problem, "No Fuse" error message

    I just tried to start my Liberty up again today and all the dome lights worked and the dash lit up but the engine never started. I attached my trickle charger and that said the battery was at 95% so I will charge it up and see if there is any draw using a multimeter. Note, yesterday she started...
  7. M

    Problem, "No Fuse" error message

    I did use a wiring harness since I didn't want to risk anything, but after I pulled my new stereo out I noticed I forgot to tape off one of the wires that I wasent using. Now this is a long shot but could that single wire have drained my battery over night or is their a deeper issue that I need...
  8. M

    Problem, "No Fuse" error message

    I checked the battery voltage and it came back as 95% when the battery terminals were connected to the battery but when I pulled the terminals off and just connected the voltage tester to the battery it was at 3%, this battery is also only a little under a year old, I replaced it right after I...
  9. M

    Problem, "No Fuse" error message

    Hello, I am new to this form. I bought my 2011 Jeep Liberty last year with minimal problems, a little over a week ago and my parents got me a new stereo, backup camera and wiring harness for the stereo (it was my birthday). I spent two days (half days) pulling my paneling apart to hide all the...

Latest posts

Members online

Top