Search results

Thanks Tom. Exactly what I was looking for. Sent from my SM-G935W8 using Tapatalk

I'm looking for some assistance... in particular a wire schematic of the rear abs wheel speed sensor wire harness. It's a 2006 Liberty. 4 channel. I had breaks in the wiring between the speed sensors and the connector located under the back seat and ran new wires. Unfortunately the system still...

I've got the case removed. When I drained the fluid afew small plastic bits came out. I can also feel something loose inside through the drain hole. Is the repair/ rebuild a good idea to be done by myself or is this a task best left to a shop to be completed? Are there any special tools or...

I kinda thought so but was hoping to avoid that. Thank you. Sent from my SGH-I337M using Tapatalk

Hello, I'm trying to remove my 242 transfer case from my 06 liberty. What is the best way to remove the bottom 2 remaining nuts? Any help is greatly appreciated.

Hello, I need some help to troubleshoot some front end noise. I can only best describe it as the sound of someone juggling a set of keys.... or dragging them maybe... Also noticed a tick while turning right only. I've looked over the front end and nothing seems out of place. Brakes are good and...

Thank you Billwill. Its 2006 sport.

Yeah. Fuse blew again.

The drivers side front and rear marker lights have stopped working. I changed the 10 amp fuse (#7) and they worked again... This morning I discovered that they no longer work again. Any ideas where to start looking? I suspect a short to ground somewhere? Any help is greatly appreciated.

Thanks for the replies. You can only feel the vibration in the steering wheel. Ill give everything a good wash and inspection this weekend. If I find anything Ill be sure to post it.

I have an 06, 3.7l auto with a strange steering wheel vibration... The steering wheel has a shake/vibration at all speeds but is more pronounced at higher speeds. Strange thing is that it is not totally speed dependant. If I set the cruise control on the highway the vibration seems to cycle off...

Bumper is removed and here is a better look of the crossmember. I think it can be massaged back into shape. Maybe weld the seams of the cracks and install some form of doubler. Open to any suggestions.

Thank you all. Your knowledge and assistance is much appreciated. I take full responsibility for the damage. I should have known better. Unfortunately sometimes we have to learn things the hard way. I was very uneasy with the angled pull but had little other options. If the weather cooperates I...

Thank you for the constructive advice. Super helpfull. Ill be sure to run all my future plans through you first...

It was actually a pretty gentle slow pull. Came out very easy. Not sure why the cross member failed the way it did so easily.

My front recievers worked awesome. I didnt have to walk home. Unfortunately my Jeep didnt. Im looking for possible repair schemes as well as upgrades to insure thus doesnt happen again. Unfortunately as you can probably tell it was an angled pull..

My appologies... I promise no more drinking and texting. Maybe my counsellor was right.... Sent from my GT-I9100M using Tapatalk

Finally got my front receivers/tow points and KC HiLites installed and wired. Also fixed my ABS, ESP, Traction Control Issues.

Sliders still available? Pics? Sent from my GT-I9100M using Tapatalk

Got my front recovery point/receivers and KC HiLites installed and wired.