Recent content by Sirthor1881

Not to Hijack but can I see some pictures of that swap....sounds interesting. Richard

Try a place like Lowe's or Home Depot. I have purchased some there before. Just an idea. Richard

Looks nice.... I am curious to see how well it holds up to the elements.

Oh yeah definately....held right at 28-30 in Hg for about 25mins or so and didn't move.

Yes, when I filled it with PAG, I drained the old compressor measured and the new one. I put back in the amount oil that was removed from the old compressor. I added the amount listed that you(TJKJ2002) had listed in a previous post for the accumulator. I put a good vacuum on it to 30 in...

Anyone have any ideas or guidance?

So I had a clutch failure on my a/c compressor. I replaced the compressor, orifice tube /In the hose, and the Accumulator. I held a vacuum on the system till 30 in hg. and left it on for about 45 mins to hour. I then charged the system. It has about 2, 12 ounce cans in it. I know it holds...

I am sure those 30lbs bottles have gone up since I last purchased them a few years ago..

Well, Just my luck that belt is not available near me....Anyone else have a good part number?

So I have searched a few threads on here and LOST, and I am looking to bypass my a/c compressor due to the clutch shorting out. I need a temp. bypass for now. My question is: Is everyone using the belt made for a kj w/o A/c, and just removing the clutch/pulley assembly? Or does anyone have a...

Yeah, I have pulled them to check them a while back, but I just thought that was strange for them to say that. I have always run Autolites, and never had issues. I ran NGK's in my turbo AWD DSM when I had it and ran high boost without any issues. Well I have it back now, I don't think I will...

So I took my 03 in for the lower ball joint recall, so they would stop calling me about it. But I had the lead Tech there tell me that I needed my Autolite plugs changed because they are bad for the engine. I questioned him as to why, but he never gave any clear reason. He told me to use only...

I was in no way shape or form even thinking about purchasing it, I just thought the front strut spacers were a strange design, maybe kinda risky too.

So what does everyone think about this lift kit? FROM EBAY PAGE: Masterkit1 now offers the best suspension lift on the market for the Jeep Liberty 2002-2007. Give your Liberty the look and the clearance it needs to go offroad with our new Suspension lift 3". Masterkit1 uses a unique...

Check out this link... http://www.jeepkj.com/forum/showthread.php?t=43522 I have thought about getting this kit also...the spring rates are supposively slightly higher than OME I have been told.