Hello to everybody,
I am driving a 2.8 CRD and after some problems I would like to install some additional gauges to control the Oil Pressure and Oil Temperature. Unfortunately I have no clue where to install the sender for both gauges.
Thank you for any ideas or help
Presents
Would like to add some gauges, but.... I am driving a 2.8 CRD and I do not have a clue how to install or mount the sensors to get the oil pressure and or oil temperature.
On the other hand I bought already an OME Suspension Kit, and a roof rack. :-)
Thanks tjkj,
the only "mods" which could maybe have an impact on the Control Unit was that the garage serviced the Jeep and coded a new key.
Yesterday I only asked them to add some wheel spacer onto the Jeep, because it was here raining cats and dogs and without having a dry place to do the mod...
Thank you guys for your replies.
Any ideas why it was reportedly not possible to get the vehicle in neutral and why the EPU was so hot?
Jeep Wave
Thomas
Hello Dave,
thank you for your reply.
To be honest, it was my first guess too, but....
Before I went to the garage I drove for at least an hour around without having any problems!!
I will keep you informed how the game is going on.
Jeep Wave
Good morning to everybody :-)
I hope that this thread is not covered already somewhere else, but I am new to this forum and haven´t found a similar thread so far.
Yesterday I drove my Jeep (2006 Liberty CRD) to the local garage to get some mods done.
After a while the guy came to ask...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.