Sons first car 2003 Jeep Liberty Limited
We replaced the bad 2003 3.7 V6 with a 2007 3.7 V6 with only 46,000 miles.
Replaced the front rotors and brakes, and replaced 2 bad tires. Charged up the A/C and finally got it all titled and licensed.
Gave it to my 15 year old son as his first...
Trans mounting
There is a bearing in the back of the crankshaft that must be removed for the tranmission snout to fit. It is easily removed and then it worked perfectly.
Used the original 2003 flywheel and transmission and the new 2007 motor and crankshaft with the bearing removed...
THIS IS NOT TRUE.
I just took a 2007 motor and placed it in a 2003 Jeep Liberty.
First you must change out the reluctor ring on the crankshaft to the older one.
Second you must replace the toner ring on the camshaft with the older.
Third you must make and install a blocking plate where the...
I just finished swapping a 2007 Jeep Liberty 3.7 V6 into my 2003 Jeep Liberty. The old engine was damaged beyond repair and I found a 2007 with low miles that I bought really inexpensively. All that had to be done to do the swap and it runs perfectly was to use the older reluctor ring onto the...
I have an 07 motor we are putting in an 03 Jeep Liberty.
1. Change the tone ring from crankshaft.
2. Change the camshaft sheetmetal ring on right head to the older style.
3. Block off egr valve
4. Use the older intake and exhausts.
5. Remove the bearing inside the rear of crankshaft(...
So far we have pulled both motors, moved the tone ring and cam ring to the new motor, and rmoved the bushing in the rear of crankshaft and are getting ready to reinstall motor. Will let you know how this works out.
Looking for a motor for 2003 Liberty Limited, 3.7 V-6 needed.
I have a complete but wrecked 2007 for parts. 3.7 V-6 with auto.
Let me know.
Used the 2007 motor in my 2003. Running great and will be parting out my 2007.
Just have to get the time.
My oldest boys Jeep had the same thing after working on it. On the other end of the wire is a small ball that fits into a notch to open the hood. If it comes out the only way to open the hood was from underneath with a 4 ft piece of wood. Then I reset the cable end into the notch and whas good...
I am new to JeepKJ.com and have just bought a 2003 Jeep Liberty Limited for my youngest son and I to work on.
The 3.7 v-6 engine is bad. It starts with a lot of rattling. Everything wlse about hte little Jeep looks pretty good.
I also bought a 2007 wrecked for parts. It has the 3.7 v-6...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.