What did you do to your jeep today?

[HoosierJeeper]

Manually timed a 5mph rolling start to 60mph run... 8.6 seconds. Not bad for the big girl.

That's faster than what I thought....I was thinking around 10 seconds...

 

[jschenck]

That's faster than what I thought....I was thinking around 10 seconds...

Well, mines an 04 limited, 4x2... Not having the extra weight of 4x4 components helps. I also was sitting on 3/8 of a tank. When my Libby shipped from the factory, her ship weight was 3675lbs. That was her as she sits now, plus 5 gallons of gas. Seems like she's on the light side compared to the typical liberty.

Keeping with the thread, I changed the tensioner pulley today.

 

[Paul M]

Not all today, but in the last week: finally mounted a decent set of tires (GY Silent Armour, 245/75-16) on new alloy wheels, added a Rola Cargo Basket on a pair of homemade custom rack rails, then washed the Winter crud off it after an oil change and lube job. Installed new and better wiper blades. Then conditioned the headlight covers to clean up the stone pits. Really need to spend a few hours detailing inside and out....always seems to run better after, as if appreciating the pampering. Had planned a new windshield today (Colorado eats them), but it's snowing. Maybe next week.

 

[ck2012]

Tried to figure out a good place to mount my new Ka-bar knife so that it is not "concealed" as the cops around here would not like to stumble upon a ten inch knife hidden under my seat if they ever "took a look around my jeep".

 

[Ry' N Jen]

Hard wired our satilite radio and CB radio

 

[hansenguy62]

I got mine serviced but thinking i got ripped off. My bill was 800us. Full mega service including diff oil change and new blower switch in the dash.
Marked the wheel nuts with marker pen and realised he didnt even take off the wheels to do brake, calliper etc inspection. Is it possible to do it properly without taking the wheels off? Jeep liberty renegade. 2005

 

[scld1354]

Hansen - rotor wear can be seen with the wheels on, but pad wear can't. Besides, doesn't a "full inspection" usually include tire rotation? That seems like a boatload of $$$ for changing fluids.

took off the front pass tire to investigate sheared wheel studs. Looks like I can get by with just replacing the studs, not the intire hub assembly.

 

[Jaber]

Cleaned it real good today. While filling up the windshield wiper fluid, I noticed my MAP sensor was missing the rightside bolt... It was replaced under warranty 4 months ago. Will this cause any issues? Looking at the manual it appears that both bolts require 25lb of tq.

 

[wheeee32]

Not all today, but in the last week: finally mounted a decent set of tires (GY Silent Armour, 245/75-16) on new alloy wheels, added a Rola Cargo Basket on a pair of homemade custom rack rails, then washed the Winter crud off it after an oil change and lube job. Installed new and better wiper blades. Then conditioned the headlight covers to clean up the stone pits. Really need to spend a few hours detailing inside and out....always seems to run better after, as if appreciating the pampering. Had planned a new windshield today (Colorado eats them), but it's snowing. Maybe next week.

Colorado definitely eats windshields. I always stayed far back from the plow trucks and never had an issue. Somebody driving in front of me on I-25 was always the source of my windshield chips/cracks....In other news I changed the oil and made a trip to Napa to get new pads and rotors for next weekend.:happy160:

 

[MSReNeGaDe]

Put new joints in this ****

You must be registered for see images

sent using the dark side of the force

 

[M'Shizzle]

What did you do to your jeep today?...

installed new windshield wiper arms today.

must now figure out what to do with the rear wiper.
looks like I will have to cut down a universal refill blade to fit the short the 11" arm. not finding ready-made replacements at the parts counter or online.

 

[Porkchop]

I get mine at auto zone if its any help

 

[MSReNeGaDe]

You must be registered for see images

You must be registered for see images

Just bought this sucker. My OEM stabilizer is leaking because it *****. This forum has pushed Bilstein so hard I've picked up on it and started buying there stuff

sent using the dark side of the force

 

[Ry' N Jen]

We used our KJ to transport many bottles of beer to our friends house where we are now opening them and pouring the contents down our throat!

 

[Scorask]

A nice wash.

 

[MSReNeGaDe]

A nice wash.

Pics or it didn't happen!!

sent using the dark side of the force

 

[Palma]

Plasti dipped the wheels, new lug nuts, and new floor mats.

 

[sevenhelmet]

Balanced the front wheels, highway vibes are ALMOST gone, got to check the torques again...

Bought oil and filters for next week.

 

[Ry' N Jen]

Our KJ is having a sleep over with a WJ!

 

[Porkchop]

Air filter, oil change, lub, new plugs, change brake fluid, cleaned cv boots, fill up and washed it.