QuickSilver
Full Access Member
OK, so my 2nd DIY following my attempt later today to replace my motor blower resistor will be replacing the master power mirror switch on the driver's door panel. I haven't found a How-to on this one yet, so I hope I can get a couple of questions answered here.
I'm coming up with two part numbers: 56010093AA and 56010094AA. As far as I can tell, 56010093AA is for heated power mirrors and 56010094AA is for power mirrors w/out the heating. Short of removing the bad switch on my Jeep and looking at the casing (wanted to hold off on this until the new part arrived), is there a way to tell if I have heated mirrors?
Looking at pics of the switch, it looks like it's a modular plug-in. But does anyone know if any soldering might be involved?
What tool would be best to remove the silver bezel (shown below). Trim tools?
Thanks!
I'm coming up with two part numbers: 56010093AA and 56010094AA. As far as I can tell, 56010093AA is for heated power mirrors and 56010094AA is for power mirrors w/out the heating. Short of removing the bad switch on my Jeep and looking at the casing (wanted to hold off on this until the new part arrived), is there a way to tell if I have heated mirrors?
Looking at pics of the switch, it looks like it's a modular plug-in. But does anyone know if any soldering might be involved?
You must be registered for see images attach
You must be registered for see images attach
What tool would be best to remove the silver bezel (shown below). Trim tools?
You must be registered for see images attach
Thanks!