looking for torque specs please

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

troyliberty

New Member
Joined
Sep 30, 2011
Messages
5
Reaction score
0
Location
Orange, MA
Hi, could someone tell me what the torque specs should be for the front & rear wheel bearing on a 2008 liberty, thanks.
 

nchorselover55

Full Access Member
Joined
Jan 31, 2008
Messages
120
Reaction score
1
Location
Cedar Point, NC
Don't know about the rear, but here is the front instructions -

1.Install the hub/bearing assembly to the vehicle.
2.Install the three mounting bolts (1) for the hub/bearing. Tighten the bolt to 130 Nm (96 ft.lbs.).
3.Install the axle shaft nut. Tighten the nut to 135 Nm (100 ft.lbs.). (if equipped with four wheel drive)
4.Install the wheel speed sensor to the hub. Tighten the bolt to 13.5 Nm (10 ft.lbs.) See: Brakes and Traction Control\Antilock Brakes / Traction Control Systems\Wheel Speed Sensor\Service and Repair\Front Wheel Speed Sensor - Installation.
5.Install the disc brake rotor See: Brakes and Traction Control\Disc Brake System\Brake Rotor/Disc\Service and Repair\Removal and Replacement\Brake Rotor - Installation.
6.Install the disc brake caliper adapter. Tighten the nut to 135 Nm (100 ft.lbs.) See: Brakes and Traction Control\Disc Brake System\Brake Rotor/Disc\Service and Repair\Removal and Replacement\Brake Rotor - Installation.
7.Install the tire and wheel assembly. See: Wheels and Tires\Service and Repair\Removal and Replacement.
 

Latest posts

Members online

Top