Alarm?

[papasmurf42482]

Anyone know how to disable the factory alarm? I know its seems stupid but i installed a remote start and now i have to carry 2 remotes because if i unlock with the aftermarket remote and open the door the alarm goes off. Help?

 

[JLRockies]

It's hard to say exactly what you may have overlooked. If the vehicle is starting by remote, it does not make sense that the OEM security is still armed. You may have other problems that you have not discovered yet.
The factory disarm wire should be at the BCM: connector 2 pin 9 (lt green w/orange). You will need to send a negative signal to this wire through a 473 ohm resistor and a relay.
If the remote start unit has a factory disarm signal wire use that, if not, use the unlock output from the aftermarket alarm.
Negative signal to relay pin#85, pin#86 to +12V, pin#30 to ground and pin#87 to the 473 ohm resistor the other end of the resistor connects to the wire on the BCM.
I am fairly sure this will work. I have an 06 so it's not the same deal. Good luck getting it done.

 

[rchung813]

Not to drive this off topic, but if my car is equiped with the default JEEP alarm, what type of alarm system is it (make/model)? Supposedly my dealer upgraded my alarm after I complained to them, but I'm not sure if they did. The alarm that I currently have makes multi sounds, meaning it will beep.. beep.. one min and the second min it will whoop whoop, etc.. the annoying alarm. I wanted to see if the dealer acutally "upgraded" me.

 

[JLRockies]

I responded to your post in the general forum. Good luck with your situation.