Search results

agreed with both the above. I had my axle replaced due to the u-joints with similar symptoms. You can also do a simple check with the brakes by feeling the rotor temperature after you get that vibration. If it's hot (as in feel an excessive amount of heat as compared to the other rotors), you...

Just to put my opinion of both companies in, I prefer Jegs way over Summit Racing. Living in Columbus, OH, I have the opportunity to shop at both places in person quite frequently. I went to Summit a couple times for a race car I used to have, and their customer service was such a pain to deal...

I believe it was one of the u-joints that went bad. My Jeep was still covered under warranty, so I didn't ask too many questions. In my case, it was hard for them to pinpoint where the problem source was, until they had a drivetrain specialist look at it and take some pieces off until he was...

glad you found them online! I was going to send you the link as I went through the same trouble. I do have a question for you though. I'm assuming that you are putting the rock rails on for the first time, and the "rivnuts" are not installed on your frame rails already. If that is so, please...

I had the exact same symptoms, at just a little bit higher rate of speed, about 25-30 mph. It started as a noise, then progressively turned into the whole jeep shaking. I'm not sure exactly how it went bad, but I ended up getting a new drive shaft. I don't know what you could look for in this...