ISO a Fuel Tank ******. that's the part that covers the top hole in the fuel tank. The nut pushes on the ****** so that the ****** will press against the o ring. gasket. Fuel lines go in & out the ****** too. It's part #2 in the picture.
TIA
This an old post, but just because the fuel pressure was good at the shop doesnt mean it's good when it dont start. Engine off - Press the schrader valve to see if any pressure is visible. Don't start a fire.
What are the most magical fixes for Idle searching 450 - 650 RPMs then stall for these Libbys?
IAC is 6 mos old. I replaced the spark plugs today because I hadn't in a while (The old ones looked good enough to go back in) No improvements.
My OTC scanner shows the 02s reading are good. TPS...
IMO whether inner or out Tie rods it's all the same to the tire.
Is there wear in the rack or rack bushings?
Yet Doing a google search, it kinda sounds like a bad alignment.
Yes, both at once. Think it;s in the manual too!
Did you check the O2 Relays and the wires going to the O2 sensor?
Also, it may not come out without taking the Cat out too. So order new gaskets, V Clamp, and Cat Bolts as well.
Yes, I do that quite often even though the AC hasnt worked in 2 years. (its fixed now)
Check the sticky for wet passenger floor https://www.jeepkj.com/threads/water-leak-passenger-side-quick-fix.54496/page-3
I just resealed this screen aka Cabin Filter. The old gasket is actually foam tape. I dont think this foam was ever meant to hold back water.
I noticed near the fender there was a passage blocked with debris. It's all clean now so no water should build up and enter the screen. But this...
Blower Resister RnR with the 2004 Sebring Convertible part RU 1040
(PN: 4885919AA, 4885919AB, 5174124AA, 4P1326, RU1040, RU347, 973-023)
NoW looking as to why I have the "passenger side wet carpet"
Some after market bulbs dont fit properly or touch all the needed contacts in the socket. check for volts in the socket.
Sometimes the wrong bulb is installed and everybody else looks at the wrong bulb and installs a New wrong bulb instead of the correct bulb.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.