Search results

Given that the steel diff is not available from JBA anymore. I have decided to try to make one myself. It first starts with a Dana 30 front axle, this one is out of a 1994 Wrangler with 3.07 gears. This one was found locally for very cheap, however it has had some water (and mud) in it for...

I built a swing out tire carrier for my Rock Lizard Bumper. The carrier pivots on the bumper with the axle and spindle kit. The original tire mounting hardware on the holds a bracket that holds the latch and polyurethane support. It has been on the jeep for over 5,000 miles without an issue...

Overall both bumpers are in good shape, free absolutely free. Please send me a direct message for scheduling pick up. Located in Dubuque, Iowa. The front bumper is trimmed for clearance and improved approach angle. Moderator, please move to the for sale section. I am unable to post there.

Just wondering if others have leaks up by their front timing cover area. It seems like the whole front area is covered up as high as the power steering pump, and it runs down the front of the engine. I have tried cleaning the area with the pressure, but with the lance being as long as it is, it...

I picked up a rock Lizard Bumper last year and am working on getting it mounted now. I assumed it just bolted right up at the factory hitch location, but it appears I have to remove some of the pinch weld at the rear to get it into place. Can any one with a rock lizard rear confirm this? Does...

Over the summer I picked up a Warn 9500i winch for cheap from a local ad. Then a few weeks later I found a used ARB bumper with in driving distance. Natively, a 9500i will not fit the ARB. It is too tall and would mount in the wrong orientation for the ARB. The bumper was is pretty rough shape...

I installed a pair of Iron Rock Off Road control arms, originally for a WJ jeep. https://www.ironrockoffroad.com/product/wj-heavy-duty-adjustable-lower-control-arms.html They are adjustable from 15.75 to 19.38 inches. The stock Liberty control arm is 17.32 inches. I have about 100 miles on...

I installed JKS kit 2030 (original for a JK) onto my KJ. At stock height, the sway bars links are about the same length, and for both vehicles use 1/2 inch (12mm) hardware at both ends. The install went pretty well, I used the longer pins with spacer on the bottom, and the shorter pins mounting...

This kit will create a spot for your transfer case to let you to go into 2WD low. This helps prevent driveline bind from being in 4WD low on high traction surfaces. This allows your transfer case to shift into the 2.72:1 (typical) ratio while still keeping the vehicle in 2WD. I have used it a...