Search results
-
B
Jacking and Lifting Point Pics
Thanks. Do you have pics of where under the front lower control arms? Seems at least one wheel needs to come off the ground to rotate things to take out the front drive shaft. Just driving up on ramps won't do that. Is there a way to go up on ramps and then jack up one wheel just to get...- Burro II
- Post #3
- Forum: KJ General Discussion
-
B
Jacking and Lifting Point Pics
The manual explains jacking for tire change purposes. The manual pic and explanation are still inadequate in my view. And there is no explanation for lifting the front of the vehicle for placing jack stands in the right place. So here are some pics for those who might be confused or new to...- Burro II
- Thread
- Replies: 11
- Forum: KJ General Discussion
-
frontliftpoint
- Burro II
- Media item
- Comments: 0
- Album: Main
-
frontjackpoint
- Burro II
- Media item
- Comments: 0
- Album: Main
-
B
What did you do to your jeep today?
Two Way Radio Mount Installed Today I fabricated a simple but sturdy mount for my VHF/UHF handheld two way radio. This was made from a heavy plastic drinking cup that fits into the cup holder. Holes, notches, and zip ties hold the small wood clip board in just the right place and angle...- Burro II
- Post #18,431
- Forum: KJ General Discussion
-
cupholderradiomount1
- Burro II
- Media item
- Comments: 0
- Album: Main
-
B
A/C Compressor Cycling---weird
But it does...with the A/C button off.- Burro II
- Post #8
- Forum: KJ General Discussion
-
B
What did you do to your jeep today?
I pick up a rear window at the JY The back light on my Liberty was etched by a wiper arm. Some DA PO was just careless with maintenance. Found a 2006 'gade with nice glass. Dark tint like I have. Swing gate was gone, but the glass was there. Interior was pretty well stripped. Had only...- Burro II
- Post #18,427
- Forum: KJ General Discussion
-
B
A/C Compressor Cycling---weird
Agree, but what the heck is it doing this for?- Burro II
- Post #5
- Forum: KJ General Discussion
-
B
What did you do to your jeep today?
Recalls Completed I picked up the Burro from the dealer today. They had finished the trailer hitch install and rear suspension arm replacement. Looks good and sounds less thumpy on the road.- Burro II
- Post #18,425
- Forum: KJ General Discussion
-
B
A/C Compressor Cycling---weird
OK, I don't claim to understand all the features on this vehicle. But the A/C compressor cycles even when no defrost or or A/C is selected. Is this normal, or is there a stuck relay or something? 2006 Sport 3.7 auto- Burro II
- Thread
- Replies: 12
- Forum: KJ General Discussion
-
B
Rear Drive Shaft Service Life?
When Burro II was up on blocks this week I took a close look at the rear drive shaft. Rusty as heck. Looks all original. 122K. The spicer joint does not seem serviceable. No apparent problems at this point. But I am curious as to typical service life of these. And is there a...- Burro II
- Thread
- Replies: 1
- Forum: KJ General Discussion
-
B
Towing flat four wire harness connections...?
Thanks everyone. This will be for a light weight utility trailer. I think I will go ahead and use a flat four wire and some diodes and keep it simple and inexpensive. I don't mind splices. And I solder and shrink wrap everything. Done it before. Just needed to know where the best tap...- Burro II
- Post #8
- Forum: KJ General Discussion
-
B
Towing flat four wire harness connections...?
I looked but could not find a "how to" or FAQ on connecting a four wire trailer light harness to the existing wires at the back of the KJ. PO never got the hitch installed under the exploding gas tank recall. I am taking El Burro into the dealer for that recall this week. Figured since I...- Burro II
- Thread
- Replies: 10
- Forum: KJ General Discussion
-
B
El Burro II Project Pics
Bought them new from Jante Wheel. $435 set of four delivered! New black lug nuts too, from same place. Less than $20 for 23 of them. Antenna mount is a simple piece of angle aluminum cut to match the curve of the rack end and secured by 3 screws into the inside of the rack end. Then a...- Burro II
- Post #6
- Forum: KJ General Discussion
-
B
Dip Sticks for Dummies
I let it drain for over two days and nights. I think at least another quart drained out. So I'm going slow putting the fluid back in. Added half a qt today. Will see where that brings it next hot drive.- Burro II
- Post #8
- Forum: KJ General Discussion
-
B
Dip Sticks for Dummies
Nope. I love the saggy look it has, can't you tell? And it rides like a buckboard, why make it harsher?- Burro II
- Post #7
- Forum: KJ General Discussion
-
B
Dip Sticks for Dummies
Sorry guys. It was a typo. It is an '06- Burro II
- Post #6
- Forum: KJ General Discussion
-
B
El Burro II Project Pics
Thanks. The original radio is model RBK. Single screw to the left of the power outlet releases the cover panel. Fours screws hold in the radio. Two plugs in the back. Sourced at 1factoryradio.com $125 delivered. Hope that helps.- Burro II
- Post #3
- Forum: KJ General Discussion
Members online
No members online now.