Search results

  1. J

    Transmission Solenoid Pack Confusion...

    How's it driving now? Everything back to A okay?
  2. J

    Lift Gate Glass Open Switch

    I recently replaced the whole lift gate on my KK. I think I may have saved that switch. I'll have to look and post back. It's yours if I did save it. I saved the window wiper motor, glass, lights and harness but I don't remember if I pulled the switch.
  3. J

    Noisy startup normal?

    I drive far from modestly. People say the liberties are slow however I'm sufficiently satisfied with the performance of mine. Probably once or twice a week I hit wot up to 80 mph. The liberty does it without any funny business or weird noises.
  4. J

    Noisy startup normal?

    I have a 2011 that just passes 118k. My Libby has made this noise upon startup since I got it with 100k. My noise is coming from the timing chain guides. It is pronounced up to 30 seconds and then goes away. Only does it upon first startup, rest of the day it is fine. Eventually if it gets worse...
  5. J

    Jeep is acting very strange?

    I have had a mass air flow sensor do this (not on a jeep but a v6 ranger) same symptoms. Ended up replacing it and then it ran fine. It wouldn't hurt at all to get a can of mass airflow sensor cleaner and give it a good cleaning along with the other troubleshooting suggestions made here.
  6. J

    Liberty 2011 Code B210D

    I second a bench test.
  7. J

    Scan Tools

    I have and used to great success the Autel Ap200 for 62 BUCKS on Amazon. It does TPMS, oil, bi-directional. I have programmed new keys. Best 62 bucks I've spent. It gives you one advanced vehicle software for free lifetime subscription. Others are 25 bucks a year. I've used it so much, I paid...
  8. J

    09 liberty no start

    Yes, it is a Chrysler feature from the factory.
  9. J

    Heat issue

    I've heard of people using CLR in the heater core. They put in, soak 3-5 minutes, the back flush thoroughly. I haven't personally tried this though.
  10. J

    Heat issue

    You're welcome, glad you got it working again.
  11. J

    Heat issue

    Since you get heat while accelerating I would not think they are the issue. If you have a temp gun check the heater hose temperature at the fire wall. That will show you the inlet and outlet.
  12. J

    Heat issue

    I have a 2011 also and the heat completely stopped working at 105k. It took a full system flush and a backflush of the heater core to get it working again. It puts out 182 from the vents now. I also had a blend door calibration done during troubleshooting of the issue. Blend doors can also be a...
  13. J

    Heat issue

    Hello and welcome, Are you showing normal operating temp? How many miles are on your Jeep? It sure sounds like you still have air in the system. There are some good links in the how to section on getting air out. It can be frustrating for sure. I would back flush the heater core and re bleed the...
  14. J

    Hub bearing issues

    Nevermind, I see you replaced the CV axle (forehead slap). Maybe your brake caliper is sticking some causing things to roast.
  15. J

    Hub bearing issues

    Thinking about the dynamics of the Front axle, it might be possible your right front CV shaft has an issue. It might be slightly out of balance, or the joints may be dry. If you get a good pair of CV Boot pliers and new clamps. I would disassemble the half mark where each ball goes. They must be...
  16. J

    Hub bearing issues

    I agree, try OEM. I replaced the hubs on my impala at 206k with Moog. Both purchased from the same auto parts store. One was good, the other was not. The replacement for the bad one is working now though. My first time getting a bad Moog part right out of the box.
  17. J

    P0302 Intermittent Misfire

    From reading many places, if you've rulled out all other potential causes for a misfire you probably need a repair to your TPCM. It's on the Passenger side of the engine bay. Essentially what happens is the coil driver circuit starts to go bad. Vehicle vibration causes a random misfire...
  18. J

    Engine or exhaust noise

    Glad you figured it out, I was going to say try a better quality fuel. My library absolutely hates gas from Sam's club pumps. It hesitates and doesn't idle happily and only gets 13 mpg with it. I put in good 100% gas and it runs great and mpg goes back to 16.7 in the city.
  19. J

    Downhill assist in 4low

    Thanks for the quick response, having never used it before I wasn't sure. I stopped a couple of times to let the brakes cool. We got down, it was a very steep long grade.
  20. J

    Downhill assist in 4low

    Hello everyone, I'm currently on vacation...yay! I took my Jeep to Moab, UT and have been out on the trails with it. Overall, I have been impressed with its off road capabilities. I had a question about the downhill assist and proper usage. On Shafer trail in Canyonlands NP I used the downhill...
Top